- DL manuals
- FCI
- Measuring Instruments
- ST75
- Installation And Operation Manual
FCI ST75 Installation And Operation Manual - page 28
Summary of ST75
Page 1
This page is subject to proprietary rights statement on last page 1 06en003368 rev. G st75/st75v mass flow meter installation and operation guide pre-installation serial number alignment the st75 and st75v (vortab) can be specified with integral or remote electronics. The flow element has a serial n...
Page 2
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 2 06en003368 rev. G specifications media compatibility: air, compressed air, nitrogen, oxygen, argon, co2, ozone, other inert gases, natural gas, and other hydrocarbon gase...
Page 3
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 3 06en003368 rev. G fci flow meters may be installed with less than the recommended straight run, but at the risk of limiting performance. Fci offers vortab flow conditione...
Page 4
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 4 06en003368 rev. G instrument wiring before opening the instrument to connect power and signal observe the following esd precautions: use a wrist band or heel strap with a...
Page 5
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 5 06en003368 rev. G pulse output activation the st75/st75v provides a pulse output feature. Instruments ordered with volumetric or mass flow units are factory set with tota...
Page 6
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 6 06en003368 rev. G setup interface all parameters on this meter are set through the rs232 interface connection (p3 plug). The rs232 interface allows the instrument to be s...
Page 7
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 7 06en003368 rev. G start-up and commissioning 1. Verify all input power and output signal wiring is correct and ready for initial power start-up. 2. Apply power to the ins...
Page 8
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 8 06en003368 rev. G rs232 / fc88 menu control and organization most entries require at least two keystrokes; a capital letter and the [enter] key, or one or more numbers an...
Page 9
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 9 06en003368 rev. G example: command v (reference table 3) case: 4-20 ma #1 = flow, 4-20 ma #2 = temperature, namur = low, source out = pulse, sink = alarm1 pressing [v] [e...
Page 10
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 10 06en003368 rev. G the fci instrument requires little maintenance. There are no moving parts or mechanical parts subject to wear in the instrument. The sensor assembly, w...
Page 11
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 11 06en003368 rev. G application verification after verifying that the flow meter is functioning, review the application parameters as shown below to verify the calibration...
Page 12
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 12 06en003368 rev. G calibration parameters verification the instrument uses a set of predetermined calibration parameters to process flow signals. Most of these parameters...
Page 13
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 13 06en003368 rev. G hardware verification equipment required: • digital multimeter • screwdriver the st75/st75v flow meter is made up of these basic components: • sensor e...
Page 14
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 14 06en003368 rev. G step 3 verify sensor element continuity and resistance. Remove sensor element cable from the bottom of the control circuit assembly. Note that two of t...
Page 15
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 15 06en003368 rev. G transmitter circuit calibration check (delta r verification) references • delta ‘r’ data sheet equipment • fc88 communicator or equivalent. • dvm • del...
Page 16
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 16 06en003368 rev. G intentionally left blank.
Page 17
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 17 06en003368 rev. G appendix a - approval information eu information flow/liquid level/temperature instrumentation visit fci on the worldwide web: www.Fluidcomponents.Com ...
Page 18
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 18 06en003368 rev. G specific conditions of use per fm16atex0008x 1. The ambient temperature range and applicable temperature class of the sensor probe is based on the maxi...
Page 19
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 19 06en003368 rev. G t2 / t300°c: -40°c t3 / t200°c: -40°c t1: -40°c safety instructions for the use of the st51/75 flow meter in hazardous areas approval fm16atex0008x/iec...
Page 20
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 20 06en003368 rev. G gb irl english - safety instructions these safety instructions are valid for the fluid components, st51/75 flow meter to the ec type approval certifica...
Page 21
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 21 06en003368 rev. G f b l consignes de sécurité ces consignes de sécurité sont valables pour le modèle st51/75 de la société fluid components (fci) conforme au certificat ...
Page 22
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 22 06en003368 rev. G p português - normas de segurança estas normas de segurança são válidas para os fluid components, st51/75 conforme o certificado de teste de modelo n.º...
Page 23: Appendix B - List Commands
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 23 06en003368 rev. G appendix b - list commands table 5. St75/st75v list of single letter commands table 6. St75/st75v list of cli commands command mnemonic command functio...
Page 24
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 24 06en003368 rev. G table 6. St75/st75v list of cli commands, cont. Command line password: 357 command mnemonic command function command description data type k[1-4] r/w k...
Page 25
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 25 06en003368 rev. G note: when invoking a write function, there must be a space separating the command characters and the data value. All read and write functions are comp...
Page 26
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 26 06en003368 rev. G intentionally left blank.
Page 27: Appendix C - Drawings
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 27 06en003368 rev. G appendix c - drawings.
Page 28
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 28 06en003368 rev. G.
Page 29
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 29 06en003368 rev. G.
Page 30
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 30 06en003368 rev. G.
Page 31
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 31 06en003368 rev. G.
Page 32
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 32 06en003368 rev. G.
Page 33
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 33 06en003368 rev. G appendix d - customer service fci provides full in-house technical support. Additional technical representation is also provided by fci field represent...
Page 34
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 34 06en003368 rev. G warranty repairs or returns fci prepays ground transportation charges for return of freight to the customer’s door. Fci reserves the right to return eq...
Page 35: Ra #______________
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 35 06en003368 rev. G fci document no. 05cs000004d [u] 1. Return customer information returning company’s name: _____________________________phone# _________________________...
Page 36
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 36 06en003368 rev. G fci document no. 05cs000004d [u] the following return authorization request form and decontamination statement must be completed, signed and faxed back...
Page 37
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 37 06en003368 rev. G goods furnished by the seller are to be within the limits and of the sizes published by the seller and subject to the seller’s standard tolerances for ...
Page 38
Fluid components international llc st75/st75v mass flow meter this page is subject to proprietary rights statement on last page 38 06en003368 rev. G notes.
Page 39
St75/st75v mass flow meter fluid components international llc this page is subject to proprietary rights statement on last page 39 06en003368 rev. G notes.
Page 40
St75/st75v mass flow meter fluid components international llc 06en003368 rev. G notice of proprietary rights this document contains confidential technical data, including trade secrets and proprietary information which is the property of fluid components international llc (fci). Disclosure of this d...