Femi 780P Instructions For Use And Maintenance Manual - page 11
7
EN
1
INTRODUCTION TO USE
Before starting work with your sawing machine, carefully
read this instructions manual so that you are familiar with
the machine and its uses and where it should not be used.
Keep this manual in a safe place.
It is an integral part of the machine and should be used for
reference in operating the machine correctly and in the
proper safety conditions.
Use the machine only and exclusively for the uses
specified below, as recommended in this manual. The
machine should not in any way be tampered with, or forced,
or used for unsuitable purposes.
1.1
SYMBOLS PLACED IN CORRESPONDANCE
WITH USAGE POINTS
Never underestimate the warnings ATTENTION -
CAUTION given in this manual.
In order to draw the users attention and to preserve safety,
hazardous operation are preceded by symbols and notes
that point out the danger and explain how to behave to
avoid any risk.
These symbols and notes are divided in three categories,
identified by the following words:
ATTENTION: dangerous-behaviours that could
cause serious injuries.
CAUTION: behaviours that could cause slight
injuries or damages to things.
NOTE: the notes preceded by this symbols are
technical and are aimed at making operations easier.
INDEX
1 INTRODUCTION TO USE ...................................... 7
2 INSTALLATION ......................................................... 9
3 ADJUSTMENT .......................................................... 9
4 USE ........................................................................ 10
5 ACCESSORIES ...................................................... 11
6 MAINTENANCE ...................................................... 11
7 TROUBLESHOOTING ........................................... 12
1.2
SAFETY AND RULES
The machine was designed and built according to the
Community Directives in force: 98/37/CE - 2006/95/CE -
2004/108/CE.
The enclosed CE Declaration of conformity, togheter with
the CE mark on product, essentially comprise and are an
integral part of the machine: both guarantee product
conformity with the aforesaid safety Directives.
1.3
SAFETY PLATES/LABELS
The safety plates/labels and indicators present on the
machine, the location of which is shown in the Figure 12,
are as follows:
- Wear noise protection devices.
- Wear safety masks or goggles.
- Do not insert the hands in this area with the
tool operating. Danger of dragging/cutting.
Matr. n. ...........
Fig. 12