Fender Bassman Bassman 100 Operating Instructions Manual - page 5
T Y P E
PR 420
PA RT NUMBERS
0 2 2 - 4 5 0 3 - 0 0 0 ( 1 2 0 V ) ;
0 2 2 - 4 5 3 3 - 0 0 0 ( 2 4 0 V ) Au s t ;
0 2 2 - 4 5 4 3 - 0 0 0 ( 2 3 0 V ) U K ;
0 2 2 - 4 5 6 3 - 0 0 0 ( 2 3 0 V ) E u r;
0 2 2 - 4 5 7 3 - 0 0 0 ( 1 0 0 V )
P OWER REQU I R E M E N T S
1 0 0 VAC, 50/60Hz: 3 6 0 W ;
1 2 0 VAC, 60Hz:3 6 0 W ;
2 3 0 VAC, 50Hz: 3 6 0 W ;
2 4 0 VAC, 50Hz: 3 6 0 W
P OWER AMPLIFIER
O U T P U T:
100W RMS into 4
Ω
@ <1%THD
S E N S I T I V I T Y:
1.1115V RMS
PRE AMPLIFIER
INPUT IMPEDA N C E :
PA S S I V E : 1 M
Ω
;
AC T I V E :
1 M
Ω
SENSITIVITY FOR FULL POW E R :
PA S S I V E :1 2 m V;
AC T I V E : 2 5 m V
NOMINAL LEVEL:
PA S S I V E :7 5 m V;
AC T I V E :1 5 0 m V
TONE CONTRO L S
B A S S : +/-15dB @ 50Hz
S E M I - PARAMETRIC CONTRO L :
MID FREQU E N C Y:150 to 1500 Hz
MID LEVEL: +/-15dB @ MID FREQUENCY setting
T R E B L E : +/-15dB @ 5kHz
EFFECTS LOOP
SEND IMPEDA N C E :
1 k
Ω
RETURN IMPEDA N C E :
2 2 k
Ω
NOMINAL LEVEL:
+ 4 d B u
S P E A K E R S
L OW FREQU E N C Y:
Fender Special Design 4
Ω
, 15”Wo o fer (Pa rt # 0 0 4 0 5 8 0 0 0 0 )
HIGH FREQU E N C Y:
Motorola Piezo Horn (Pa rt # 0 0 5 3 6 4 1 0 0 0 )
D I M E N S I O N S
H E I G H T:
24 1/4 in.
61.6 cm
W I D T H :
23 in.
58.4 cm
D E P T H :
12 1/2 in.
31.8 cm
W E I G H T
65 lb.
29.5 kg
Product specifications are subject to change without notice.
5
A . IEC LINE CORD CONNECTOR - The power
line cord must be connected to a grounded AC
receptacle in accordance with the voltage and
f requency ratings as shown on the Rear Panel
of the
, INPUT POWER {B} .
C . GROUND LIFT - Switch IN disconnects
g round connection fro m the LINE OUT {D} jack
(pin-1) which may reduce noise in the gro u n d
c i rcuit. Switch OUT is usually the best setting.
D . LINE OUT - Balanced XLR jack for output to
re c o rding or sound-re i n f o rcement equipment.
E . LINE OUT LEVEL - Adjusts the output level
o f LINE OUT {D} jack.
F. PRE/POST EQUALIZATION
-
Switch IN supplies the LINE OUT {D}
jack with the p o s t - e q u a l i z a t i o n s i g-
nal from the amplifier. Switch OUT
supplies the LINE OUT {D} jack with
the p re - e q u a l i z a t i o n ( d ry) signal.
G . TUNER - Connect your bass
guitar tuner here. This output jack is NOT
disabled by Front Panel M U T E switch, allow-
ing quiet tuning with the bass guitar plugged
into the
.
H . EFFECTS RETURN - Connect cable f ro m
e x t e rnal effects devices at this jack.
I . EFFECTS SEND - Connect cable to e x t e rn a l
e ffects devices at this jack.
•
N O T E : For additional output, link two
’s
together by connecting the EFFECTS SEND {I} f rom the
“ p r i m a ry” amp to the EFFECTS RETURN {H} of the
“ s e c o n d a ry” amp. All settings on p r i m a ry amp will con-
t rol the s e c o n d a ry amp settings e x c e p t MASTER VOL-
U M E which must be set on each
.