Ferguson RCU640 User Manual - Rcu640 V.2
3
RCU640 v.2
ENGLISH
Setup TV via brand name code
1. Switch on the TV for which you wish to use
the remote control.
2. Find the code number of your TV brand in
the code list (e.g. LG 0009; 0051; 0059; …).
3. Press TV button for three seconds The
POWER button on your remote control
lights up, i.e. RCU640 is in set-up mode.
4. Enter the 4-digit device code (e.g. 0051
for LG TV set). If an entry does not occur
within 10 seconds, the set-up mode is
automatically terminated.
5. The POWER button LED goes out if the
remote control accepts the code.
If the POWER button LED flashes three
times the code is incorrect; and you need
to start from step 2.
If this occurs, re-enter the correct code
from the list.
6. Check the function of the buttons on your
remote control. If the majority of the but-
tons on your new remote control do not
function correctly, enter another 4-digit
device code (e.g. 0059…) from the list
under the same brand name. Repeat steps
3 to 6 until all the basic functions operate
correctly. The TV is set up correctly as soon
as you enter the correct code.
NOTE: Exit the set-up mode by pressing
the TV button or OK button. The set-up
mode is automatically terminated if a
button is not pressed during a 10 second
period.
Setup TV via manual search
1. Switch on the TV for which you wish to use
the remote control.
2. Point the remote control at the TV. Press
and hold down the TV button for three
seconds. Then release the button.
3. The POWER button lights up and the
remote control is in set-up mode.
4. Press the VOL+ button approx. every 1.5
seconds. The device should start to flash,
i.e. the device is in Manual Search mode.
5. As soon as the TV volume changes, press
TV button to save the codes and exit from
Manual Search mode, now the POWER
button light goes off.
6. Check whether the other buttons on the
remote control function correctly. If the
majority of the buttons do not function
correctly, press the VOL+ button approx.
every 1.5 seconds to initiate the reactive
code (manual search is continued, see
steps 4 to 5).
NOTE: Sometime, remote control does not
work properly just because Manual search
does not stop in time. In this case, just
enter into Manual search again, and press
Vol– button approx. every 1.5 seconds to
search backward the code.
NOTE: The Manual Search is automatically
terminated if no entry occurs during a 10
second period.
NOTE: Entering the auto searching mode,
it will search forward from the current
code.