Ferroli LIFE User Manual - page 24
8
STARTING
POWERING THE AIR CONDITIONER
Press the ON/OFF button (Fig. 3) to power the air conditioner.
The indicator light of the conditioner will come on to indicate that it has started. Re-
member that the liquid crystal display will always indicate the last operating mode
and previously used functions. Comply with the instructions if you wish to change
the operating mode of the system
Fig. 3
HOW TO USE THE BUTTONS
By pressing the "MODE" button (Fig. 2) it is possible to select the operating
modes (Fig. 3) you prefer, choosing between the following ones:
AUTO -
COOL - DRY - HEAT - FAN .
1 .AUTO Mode- Automatic: this function is selected by pres-
sing the "MODE" button until the relative Symbol appears
on the display. The conditioner automatically sets the sui-
table operating mode (COOL, DRY, HEAT, FAN) depending
on room temperature. The temperature can be set within a
range of 17
°C ~ 30°C in 1O°C increments.
2 .COOL Mode- Cooling: this function is selected by pres-
sing the "MODE" button until the relative Symbol appears
on the display. The unit begins to operate if the set tempe-
rature is lower than that of the room. The temperature can
be set within a range of 17
°C ~ 30°C in 1O°C increments.
3 .DRY Mode - Dehumidifying : this function is selected by
Fig. 4
pressing the "MODE" button until the relative Symbol appears on the display. The unit will begin to operate in the
cooling mode, and will quickly reach the required ambient temperature. Condensation may form on the delivery
port if the "DRY" function is used for a long period of time (the fan seed isn’t adjustable). The temperature can be
set within a range of 17
°C ~ 30°C in 1O°C increments.
4 .HEAT Mode- Heating: this function is selected by pressing the "MODE" button until the relative Symbol appears
on the display. The unit begins to operate if the set temperature is higher than that of the room.
The temperature can be set within a range of 17
°C ~ 30°C in 1O°C increments.
5 .FAN Mode- Ventilation: this function is selected by pressing the "MODE" button until the relative Symbol appe-
ars on the display and the unit get the air automatically circulating in the room. When operating in ventilation alone
can not set a value for set point.
Note: When outdoor temperature is low but high humidity, after a long
while running,
frost will form on outdoor unit, that will effect the heating effect, at this
time, the auto defrosting function will act, the heat running will stop for
8-10mins. During the auto defrosting, the indoor indicator
LED
defrost
on the frontal panel
, the outdoor unit may emit vapor. This is due to the
defrosting, it isn't malfunction. After defrosting finished, the heating will
recover automatically.