Fervi 0554 User And Maintenance Manual - 2.3 Technical Support
MACHINES AND
ACCESSORIES
Page 8 of 31
2.2 Safety Regulations for Electrical Machine Equipment
Changes in the Electrical System
Do not modify the electrical system in any way. Any attempt in this regard may jeopardize
the operation of electrical devices, thus causing malfunction or accident.
Work carried out in the electrical system of the machine must, therefore, be carried out
only by qualified and authorized personnel.
If one hears unusual noises, or feels something strange, immediately stop the machine.
Then carry out an inspection and, if necessary, perform any repairs as required.
1.
The supply voltage must correspond to that stated on the label and in the technical
specifications. Never use any other type of power supply.
2.
The use of a life-saving device on the electric power supply for a nominal trip range of 10
to 30 mA is recommended. For more detailed information, contact a trusted electrician.
3.
The mains socket type is required to be tripolar grounded 10/16 A, 230 V), extension
cables must have sections that are the same or greater than the sections of the power
cable of the machine.
4.
Make sure that the power cord does not come into contact with hot objects, wet or oiled
surfaces, and/or sharp edges.
5.
The power cord should be checked regularly and before each use to check for signs of
damage or wear. If these are not in good condition, do not use the machine and replace
the cable.
6.
Do not use the power cord to lift the machine or to remove the plug from the socket.
2.3 Technical Support
For any problems or concerns, please contact, without hesitation, the Customer Service
Department of the dealer from whom you purchased the product, who has competent and
specialised staff, specific equipment and spare parts.
2.4 Other Provisions
P
ROHIBITION OF TAMPERING WITH SAFETY DEVICES
Check the presence and integrity of protections and the proper functioning of safety devices
before starting operation.
If any defect is encountered, do not use the Bench grinding machine !!
It is strictly forbidden to modify or remove guards, safety devices, labels and
caution signs.