Festool PSBC 420 EB Original Operating Manual - page 15
PSC 420 EB, PSBC 420 EB
15
GB
Original operating manual
1
Symbols
2
Safety instructions
2.1
General safety instructions
WARNING! Read all safety warnings, in-
structions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
2.2
Machine-related safety instructions
– Hold power tool by insulated gripping surface,
when performing an operation where the cut-
ting accessory may contact hidden wiring. Cut-
ting accessory contacting "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
– Festool electric power tools must only be in-
stalled on work tables provided by Festool for
this purpose. If the tool is installed in another, or
self-made, work table, it can become unstable
and result in serious accidents.
– Wait until the power tool stops completely until
placing it down. The tool can become entangled
and lead to a loss of control of the power tool.
– Deformed or cracked saw blades and saw blades
with blunt or broken cutting edges must not be
used.
– Always place the pendulum jigsaw on the work-
piece with the saw blade running.
– Wear suitable protection such as ear protection,
safety goggles, a dust mask for work which gen-
1
Symbols................................................ 15
2
Safety instructions ............................... 15
2.1
General safety instructions.................. 15
2.2
Machine-related safety instructions.... 15
2.3
Metal processing.................................. 16
2.4
Emission levels .................................... 16
3
Intended use......................................... 16
4
Technical data ...................................... 16
5
Machine features ................................. 17
6
Commissioning .................................... 17
6.1
Changing the battery pack [2].............. 17
6.2
Switch on/off ........................................ 17
7
Settings ................................................ 17
7.1
Changing tools ..................................... 17
7.2
Using the chip guard ............................ 18
7.3
Inserting the splinterguard .................. 18
7.4
Changing saw table.............................. 18
7.5
Dust extraction ..................................... 18
7.6
Adjusting the pendulum stroke............ 18
7.7
Stroke speed control ............................ 19
8
Working with the machine ................... 19
8.1
Lighting ................................................ 19
8.2
Acoustic warning signals ..................... 19
9
Service and maintenance..................... 19
10
Accessories .......................................... 20
10.1
Saw blades, other accessories ............ 20
10.2
Sawing with special base runners....... 20
10.3
Sawing with the angle table ................. 20
10.4
Sawing with the adaptation table......... 20
11
Environment ......................................... 21
Symbol Significance
Warning of general danger
Risk of electric shock
Read operating instructions and safety
notices!
Wear ear protection.
Wear protective gloves.
Wear a dust mask.
Wear protective goggles.
Do not dispose of as domestic waste.
Tip or advice
Handling instruction
Symbol Significance