Fetco CBS-1131-XV+ User's Manual & Operating Manual - ↓
Go to fetco.com for the latest versions of all information
Page 4
User Guide & Operator instructions
P166
Re0
NOVEMBER 2017
Starting The Brew
1. Turn the power switch “ON”. (Twin Shown)
2. Prepare a brew basket with the correct sizefilter and appropriate amount of coffee.
3. Slide the brew basket completely into therails.
4. Place a clean, empty, preheated dispenserunder the brew basket.
5. Select a batch & hold the corresponding BREW button infor 1 second to start
6. -STOP button will illuminate,
-Countdown time will display,
-Selected BREW button will flash to indicate brew is in progress.
-All other BREW buttons for that brew head will extinguish.
7. When the brew cycle is finished,
STOPbutton will extinguish and the BREW button willcontinue to flash for the amount
of timeprogrammed into the DRIP DELAY setting.
Thisindicates that coffee may still be dripping fromthe brew basket
For safety- do not remove brew basket until drip-out is complete.
Twin Brewer ready to brew. Pressing top right brew position
Brewing-see #6 above
Enter Programming
Screens shown are for twin brewer. Single brewer will not have menu A4-A6.
There are five menu groups-A-E . See the following pages for the batch parameter definitions and all settings for the brewer
TO ENTER PROGAMMING
1-Turn brewer “OFF” from power switch
2-Turn power switch to “ON”
…Screen will initialize and then
display digital process notifications
3-After Initialization-Red “STOP” Lamp turns on
4-Quickly hold down “STOP” button for 5 seconds
When brewer is In PROGRAMMING MODE
-the screen will display:
|BATCH PRG|
|A
(or B-E) |
-
Illuminated LED indicates active keypad positions
See the following pages for batch parameter
definitions and all settings for the brewer
Turn power OFF
Turn power ON
Wait for red LED
And quickly hold down
STOP button on front
touch panel for 5 sec.
First screen will display
for PROGAMMING-A
Scroll through main menu
topics by pressing
“STOP” button.
Exit Programming & Save Control Setting Changes
From any screen-
Press STOP button
until the EXIT (“F”)
screen appears
From the “F” screen
Press button 2 to
toggle to the EXIT-
YES
screen
From EXIT screen
Press button 1 to
toggle to the SAVE
screen
From SAVE screen
Press button 2 to
toggle to the SAVE-
YES
screen
To SAVE and EXIT
Press button 1 to
SAVE your changes
and EXIT
READY BREW
05:30
STOP
STOP
STOP BUTTON
↓
ON/OFF switch
is located on
lower right on
back of brewer
LOADING
STOP
STOP
Batch PRG
A
STOP
STOP
1
2
3
Programming A-F
A - F
STOP
STOP
1
2
3
EXIT
F NO
+
STOP
STOP
1
2
3
EXIT
F YES
-
STOP
STOP
1
2
3
SAVE
F NO
+
STOP
STOP
1
2
3
SAVE
F YES
-
STOP
STOP
READY READY
STOP
STOP