Fetco HWD-2110 TOD User Manual - Fetco
2
FETCO
®
Temperature on Demand Hot Water Dispenser
Contact Information
FETCO
®
Food Equipment Technologies Company
600 Rose Road
Lake Zurich
• IL • 60047-0429 • USA
Internet: www.fetco.com
Phone: (800) 338-2699 (US & Canada)
(847) 719-3000
Fax: (847) 719-3001
Email: sales@fetco.com
techsupport@fetco.com
Description & Features
The following variables are adjustable:
Four selectable hot water dispense temperatures ---Water temperature selectable from 158°F/70°C to 205°F/97°C
English and Metric temperature ranges selectable
Maximum single dispense is 22 ounces/700cc in 15 seconds maximum dispense time
Specifications
.
Electrical Configurations-DOMESTIC
Configuration
Code
Heater
Configuration
Voltage Phase Wires
Electrical
Connection
KW
Maximum
Amp Draw
Gallons/Hour
H211010
1 X 5 kW
208-240
1
2+G
NEMA 6-30P plug
3.9-5.1
18.1-21
10.3-13.5gallon*/39-51 liter
Electrical Configurations-EXPORT & CANADA
H211020
1 X 5 kW
200-240
1
2+G
Cord Only†
3.6-5.1
17.4-21
9.5-13.5gallon*/36-51 liter
*NOTE: Temperature ranges selectable from 158°-203°F/70-95°C based on 207°F/97°C hot water tank temperature.
† For EXPORT, Cord without plug will be attached
Temperature of dispensed hot water may vary up to 3 ½ % of displayed temperature selection.
*Flow rate per hour based on 65-70°F/18-21°C mains water supply temperature at lowest possible electrical supply current
*Factors affecting temperature accuracy include quantity of hot water dispensed, ambient air temperature, distance of container from hot water faucet (pouring over longer distance causes more cooling)
Power Plug Configurations
Pressure: 40-75 psig, (276-517kPa)
Minimum Flow Rate: 1½gpm (5.7lpm)
Water Requirements:
Water connection inlet: ¼ inch male flare fitting
Weights and Capacities
Dispenser Model
Height
Width
Depth
Water tank capacity Empty Weight Filled Weight Shipping Weight
HWD-2110 TOD 24 1/2 in/62 cm 10 in/25.4 cm 19 1/2 in/49.5 cm 4.6 gallon/17.4 liter
30 lbs/13.6 kg 68.3 lbs/31 kg
44 lbs/20 kg
NEW TECHNOLOGICAL FEATURES
The FETCO hot water dispenser uses new
t
∫
f
Touch Function Selector Technology to operate the hot water dispenser.
The
t
∫
f
Touch Function Selector buttons (above and below display screen) alternately dim and brighten when selection is not active.
Dispensing and Feature Selections activate when touched. The front panel is clean and uncluttered.
The display screen shows four temperature selections and the readiness status of each level.
Programming, display and error codes are interactive and more intuitive.
Float indicator is built into drip tray to help simplify maintenance and cleaning.
NEMA PLUG CONFIGURATION
NEMA 6-30P