Fetco HWD-2110 TOD User Manual - page 6
6
Control and Operational Screens
The FETCO® Temperature on Demand Hot Water Dispenser uses a digital display screen and two illuminated touch pads to
control the selection and actuation of on-off functions.
The two upper and lower pads are lighted when ready, and may alternately brighten and dim.
Touch upper (white) pad to scroll & select action.
Touch lower (red) pad to perform action.
-On start-up the “HOME SCREEN” screen will light for two to three (2-3) seconds
-“FILLING” screen will display during tank fill-followed by the “HEATING” screen when tank is full.
-“DISPENSE ENABLED SCREEN” will display after proper hot water tank temperature is achieved
- Touch the upper (white) selector pad to scroll through temperatures and select desired temperature
-Touch and hold lower (red) pad to dispense selected water temperature.
-After three (3) seconds inactivity -screen returns to display “DISPENSE ENABLED SCREEN”.
-Default temperature settings are (203°F, 195°F, 185°F,175°F). 203°F is T1, 195°F=T2, 185°F=T3,175°F=T4.
-Temperatures are set in the programming menus. See the “PROGRAM” screens in following section
-Highest temperature starts at T1.
-“DEFAULT” is the temperature that will be highlighted for first selection.
-“TLast” is last selected temperature highlighted that will remain for next dispense first selection
-“DEFAULT” temperature can be set for T1, T2, T3, T4 or TLAST.
HOME SCREEN
First screen on start-up
HEATING
No temperatures ready
DISPENSE ENABLED screen
Touch to go to next screen
To operate screens below
Two temperature levels ready
Temperature 185°F selected
Two lower temperatures ready
Temperature 195°F selected
But not at temperature
Three temperature levels ready
Temperature 195°F selected
Hot water dispense only at
programmed temperature
Fault state, Error.
Screen will pulse and lock out
dispense
203° F
203° F
203° F
Upper selector
scrolls through
menu
Lower selector
activates selection
NEXT (3)
FIRST (1)
READY
NEXT (2 )