Fhiaba Classic Series User Manual - page 11
9
4
4.3
4.4
4.2
www.fhiaba.com ∙ info@fhiaba.com ∙ Info Line 800-344222 ∙ Tel +39 (0)434 420160 ∙ Fax +39 (0)434 420161
An integrated control system provides information through lighted signals
or text messages visualized on the display.
The information signal is always visualized with a fixed text message, while
a malfunction signal is visualized with blinking text. The sound signal that
accompanies some malfunction signals can be deactivated by pressing
the Alarm button
on the main control panel.
The list of malfunction signals is located at the back of this manual.
Appliance switching on and off
Each model has been carefully tested before leaving the factory and is
adjusted in such a way to ensure high performance and low consump-
tion. Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is possible to modify the set
temperatures as follows:
Refrigeration Compartment
Fresco Compartment
Freezer Compartment
(TriMode)
From +2°C to +8°C (from 35.6°F to 46.4°F), the recommended preset tem-
perature is +5°C (41°F).
To adjust the temperature use the Up/Down buttons
. Upon touching
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem-
perature.
From -2°C to +2°C (from 28.4°F to 35.6°F), the recommended preset tem-
perature is 0°C (32°F).
To adjust the temperature use the Up/Down buttons
. Upon touching
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem-
perature.
From -15°C to -22°C (from 5°F to -7.6°F), the recommended temperature
is preset at -18° (0°F).
To adjust the temperature use the Up/Down buttons
. Upon touching
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem-
perature.
In case the compartment is used as refrigerator or Fresco compartment
(TriMode function) the recommended and preset temperatures will cor-
respond to those indicated for the respective compartments.
The temperature shown can vary slightly in respect
to the set temperature following frequent openings
of the doors or insertion of room temperature foods
or large quantities of foods.
6 to 12 hours are necessary to reach the selected
temperature.
Ice Maker Activation
That Ice Maker button
located on the main control panel permits ac-
tivation of the automatic icemaker. The button is lighted when the ice-
maker is functioning.
A prewash of the hydraulic circuit should be performed before activating
the Ice Maker for the first time. To do this touch at the same time buttons
Enter
and Ice Maker
.
After a few minutes the Ice Maker can be activated.
Information and malfunction messages on the display
How to adjust the temperature for different requirements
Do not activate the Ice Maker unless the appliance
is connected to the water mains.