Fhiaba Classic Series User Manual - page 27
25
12
12.2
Power Failure
Fridge door open
Freezer door open
No water
Replace filter cartridge
Water circuit problem
Fridge too warm
Fridge too cold
Frischefach too warm
Frischefach too cold
Freezer too warm
Freezer too cold
Error Code... Call service
www.fhiaba.com ∙ info@fhiaba.com ∙ Info Line 800-344222 ∙ Tel +39 (0)434 420160 ∙ Fax +39 (0)434 420161
Display message
Malfunction description
Prolonged interruption of electrical power
the appliance resumes work automatically, the display shows the warmest temperatures
achieved
Fridge door open
the message appears after one minute from the door opening
Freezer door open
the message appears after one minute from the door opening
No water
filter not replaced when required or filter status not reset after replacement
Replace filter cartridge
message appears when only 30% of filter capacity is left
Water circuit problem
water leak of fault to the water system: call Customer Care for advice
Fridge too warm
see Troubleshooting Guide
Fridge too cold
wait for 12 hours: if malfunction persists call Customer Care for advice
Fresco Compartment too warm
see Troubleshooting Guide
Fresco Compartment too cold
wait for 12 hours: if malfunction persists call Customer Care for advice
Freezer too warm
see Troubleshooting Guide
Freezer too cold
wait for 12 hours: if malfunction persists call Customer Care for advice
Functioning problems
call Customer Care who may put you in contact with the nearest Fhiaba Service Agent
Troubleshooting Guide
On average, the Ice Maker produces approximately 10 cubes of ice
every two hours.
When the Ice Maker is started for the first time, it is recommended to
empty the first full tray of ice cubes.
If the refrigerator was switched off for more than one month or if the car-
tridge was not changed for more than six months, it could be necessary to
replace the filter cartridge.
Contact a plumber or a water treatment expert to make sure that the
problem is not due to the water supply.
If the ice is not used frequently, it is possible that blocks of ice may form.
It is recommended to remove the block of ice cubes and then let the Ice
Maker fill the ice tray again.
Make sure that the Ice Maker is on (Icemaker button
on).
To switch on the Ice Maker press the button.
Make sure that the appliance is connected to the water supply.
The Ice Maker does not produce
sufficient amounts of ice
The ice has an unusual flavor or color
The ice cubes freeze into one block
The Ice Maker does not work
Malfunction indications appearing on the display