Fiat Blue&Me User Manual - page 25
24
BLUE&ME
™
in conjunction with Instant Nav
To use the voice commands with this
hands free system there is no need for any
learning stage for the system with your
voice.
To give the system a voice command,
press
‘
and wait for the acoustic signal
that indicates that the voice recognition
system is activated; you can now give the
command in your normal voice, not too
quickly but without a break. When the
system recognizes the command, it will re-
spond or carry out an action.
The voice commands are organized in
three levels: 1
st
level, 2
nd
level and 3
rd
lev-
el.
When a 1
st
level valid* voice command is
given, the system is prepared to recognize
2
nd
level voice commands; when a 2
nd
lev-
el voice command is given, the system is
activated to recognize 3
rd
level voice com-
mands.
If the user gives a valid * 1
st
level voice
command, the submenu for that command
remains activated until a voice command
that leads to another level is given or the
interaction is interrupted; the same rule is
valid for the lower levels (2 and 3).
For a list of all the available voice com-
mands, refer to the LIST OF AVAILABLE
VOICE COMMANDS chapter.
To listen to the last message given by the
system again, press
‘
for more than 1
second or press
‘
for a short while and
say “Repeat”.
The hands free system can provide in-
formation vocally.
A voice announcement is a voice mes-
sage proposed directly by the system. To
end a voice announcement, press ESC or
press
‘
and say “Cancel”.
A voice interaction is an exchange of
communications/commands between the
hands free system and the user. To start
a voice interaction, press
‘
and make a
command. To interrupt an interaction and
start a new interaction, press
‘
at any
time during the interaction and give a
voice command.
To end an interaction, press ESC. You
will hear an acoustic signal that means that
the voice recognition has been deactivat-
ed.
The help function can provide you, at any
time, with a list of commands available at
the level you are at. To use the help sys-
tem, say “Help”, listen to the list of com-
mands available and decide which com-
mand you want to give the system.
Adjust the volume to the level that is
best for you with the car moving. To
adjust the pre-set system volume, refer
to the description in the “EXTERNAL
AUDIO VOL function” paragraph in the
Instant Nav instruction manual. To tem-
porarily adjust the volume of the phone
call in profress, press + or – or adjust the
position of the Instant Nav control. The
volume will return to the original level at
the end of the call.
You can also press + of – to adjust the
volume of a voice announcement whilst
it is being given by the system.
Remember that to interrupt a voice an-
nouncement, you can press
‘
at any time
during a voice interaction and give a new
voice command.
* Valid means that the voice command is part of the system vocabulary and therefore recognizable at a given level.
603_97_160 CROMA_BLUE INSTANT NAV_GB_1ed 5-05-2009 15:51 Pagina 24