Fiat Blue&Me User Manual - page 69
68
BLUE&ME
™
in conjunction with Instant Nav
Problem
Probable Cause
Possible Solution
The display shows: REG. FAILED
Or the system says
“Registration failed. Start again,
please”
The display shows: PRIVATE NUMBER
The display shows:
ONLY WHEN STATIONARY
Or the system says:
“This function is only activated
with the car stationary”
Repeat the registration procedure. Whilst
entering the PIN, check that the PIN you
are entering into your mobile phone is the
same as the one shown on the panel
multifunction display
SETTING FUNCTIONS - MOBILE
PHONE REGISTRATION
Enter a contact corresponding to the number
of the incoming call in your mobile phone
directory and then download the new
directory/ contact onto the hands free system
In this case there is nothing that can be done
and the message will always appear
Stop the car and try to activate the function
manually or continue driving and carry out the
function using the voice recognition system
Three minutes after the system
provides the PIN, required for
registering the mobile phone, the code
is no longer accepted by the system
– The caller is not recognized as being
saved in the phone directory and the
mobile phone registered is not
capable of displaying the identity of the
caller
– The caller has disabled the sending of
their identification to prevent their
name and/or number being displayed
Even just glancing occasionally at the
panel can be dangerous and distract
your attention away from the road.
Some system functions require the
user to pay attention to the panel
display and are only available when the
car is stationary
603_97_160 CROMA_BLUE INSTANT NAV_GB_1ed 5-05-2009 15:52 Pagina 68