Fiat Doblo Owner's Handbook Manual - page 129
128
IN AN EMERGENCY
– make sure the compressor switch
E-fig. 16f is set to 0 (off), start the en-
gine and fit plug D-fig. 16e into the
nearest current outlet and then turn
on the compressor by setting switch
E-fig. 16f to I (on). Inflate the tyre to
the pressure specified in paragraph
“Inflation pressure” in section “Tech-
nical Specifications”. Check tyre pres-
sure on gauge F with compressor off
to obtain precise reading;
– if after 5 minutes it is still impossi-
ble to reach at least 1.5 bar, disengage
compressor from valve and current
outlet, then move the vehicle forth for
approx. ten metres in order to dis-
tribute the sealing fluid inside the tyre
evenly, then repeat the inflation oper-
ation;
– If after this operation it is still im-
possible after 5 minutes to reach at
least 1.8 bar, do not start driving since
the tyre is excessively damaged and
the quick tyre repair kit cannot guar-
antee suitable sealing, contact Fiat
Dealership;
– if reaching the tyre pressure spec-
ified in paragraph “Inflation pressure”
in section “Technical Specifications”,
start driving immediately;
Apply the sticker in a vis-
ible position for the driver
to indicate that the tyre
has been treated with the quick
tyre repair kit. Drive carefully es-
pecially when cornering. Do not
exceed 80 km/h. Avoid heavy
braking and accelerating.
fig. 16c
F0A0714b
fig. 16d
F0A0715b
fig. 16e
F0A0539b
fig. 16f
F0A0545b
119-148 Doblo GB 9-05-2008 12:09 Pagina 128