Foxun SX-SPH2-100 Operating Instructions Manual - page 4
Operating Instructions
4
Front Panel
Rear Panel
Power ON/OFF
Status indicator lamp:The LED will illuminate when the HDMI equipment is connected.
Power indicator lamp:The LED will illuminate when the power is on.
Reset key
Power input port
RS232 port
1
2
3
4
Ethernet port Output1 port ( Ethernet,RS232 &IR pass-though)
Output2 port ( IR pass-though)
1
2
3
4
5
6
HDMI input port
Connecting and operating
1) Connect the HDMI input sources into HDBaseT splitter.
2) Connect HDMI receiver over Cat5e/Cat6 cables to both the Cat5e/6 port of HDBaseT Splitter
and Cat5e/6 port of Receiver,The RJ45 connections must follow EIA-TIA 568b standards.
3) Connect the HDMI output from the Receiver(RX) into the display HDMI input.
emitter onto the source IR windows. .
5) Connect IR-RX cable into IR-RX port on the receiver and af
x the receiver on the display frame
/bezel or the display stand.
Note:Do not a x the emitter until the placement is tested.
6) Power up all units, the splitter,Receiver, sources and displays.
Note: Do not affix the emitter until the placement is tested.