Foxun SX-SPH2-100 Operating Instructions Manual - page 5
Front Panel
Rear Panel
Power ON/OFF
Status indicator lamp:The LED will illuminate when the HDMI equipment is connected.
Power indicator lamp:The LED will illuminate when the power is on.
Reset key
Power input port
RS232 port
1
2
3
4
Ethernet port Output1 port ( Ethernet,RS232 &IR pass-though)
Output2 port ( IR pass-though)
1
2
3
4
5
6
HDMI input port
Connecting and operating
1) Connect the HDMI input sources into HDBaseT splitter.
2) Connect HDMI receiver over Cat5e/Cat6 cables to both the Cat5e/6 port of HDBaseT Splitter
and Cat5e/6 port of Receiver,The RJ45 connections must follow EIA-TIA 568b standards.
3) Connect the HDMI output from the Receiver(RX) into the display HDMI input.
emitter onto the source IR windows. .
5) Connect IR-RX cable into IR-RX port on the receiver and af
x the receiver on the display frame
/bezel or the display stand.
Note:Do not a x the emitter until the placement is tested.
6) Power up all units, the splitter,Receiver, sources and displays.
Operating Instructions
5
Front Panel
Rear Panel
Power ON/OFF
Status indicator lamp:The LED will illuminate when the HDMI equipment is connected.
Power indicator lamp:The LED will illuminate when the power is on.
Reset key
Power input port
RS232 port
1
2
3
4
Output1 port ( RS232&IR pass-though)
Output2 port ( IR pass-though)
1
2
3
4
5
HDMI input port
Connecting and operating
1) Connect the HDMI input sources into HDBaseT splitter.
2) Connect HDMI receiver over Cat5e/Cat6 cables to both the Cat5e/6 port of HDBaseT Splitter
and Cat5e/6 port of Receiver,The RJ45 connections must follow EIA-TIA 568b standards.
3) Connect the HDMI output from the Receiver(RX) into the display HDMI input.
emitter onto the source IR windows. .
5) Connect IR-RX cable into IR-RX port on the receiver and af
x the receiver on the display frame
/bezel or the display stand.
Note:Do not a x the emitter until the placement is tested.
6) Power up all units, the splitter,Receiver, sources and displays.
HDMI cable
Output1
Ethernet cable
Smart TV
HDTV
HDMI cable
HDMI cable
RS232 cable
Router
Internet
RS-232 pin assignment
HDBaseT Splitter
PIN
Assignment
1
NC
2
TX
3
RX
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
7) To get on the ethernet,pls connect as below steps:
1.Connect ethernet cable into ethernet port on HDBaseT splitter.
2.Connect ethernet cable with TV and ethernet extender receiver
Note:1.The ethernet function is designed for ethernet compatible receiver units only.
2.Only output1 with ethernet function.
8) Copy EDID function
Copy the EDID of the sink which connected the OUTPUT1,it is suggested to put lowest or
For example:
One SDTV(480p) ,one HDTV(1080p), in order to make the 2 TV work, you need to put the
SDTV is connected to the output 1 .
Computer RS232 port
PIN
Assignment
1
NC
2
RX
3
TX
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC