G-lec s-drive ii quick start guide version 0.1, april 2010 refers to s-drive firmware 1.4, g-lec software 3.5.19 g-lec vision gmbh s-drive ii quick setup guide page 1.
Contents contents.................................................................................................................................................2 about this manual..........................................................................................................................
Safety precautions – this equipment must be earthed – ip 20. Do not expose to rain, moisture, dust or heat (like direct sunlight) – no user-serviceable parts inside, do not open. – caution: high voltage, possible hazard when unit is open and connected to mains voltage – this unit outputs laser radia...
System requirements – g-lec phantom frames, with accessories (power supplies, cabling, suspension etc.) – mains power (90-240 v, 50/60 hz) – dvi-d source (standard computer, video converter or similar). Please note that it needs to be dvi-d. Any hard-wired adapter vga-dvi will output dvi-a, and will...
Indicator leds: sync: steady on: dvi present, fiber chain established blinking: fiber chain established, dvi failure off: fiber chain failure dvi: steady on: dvi present steady off: dvi not present (not connected or no signal) (version 1.4) fast blinking: dvi present but cropping area entirely outsi...
Installation (1) hook-up the components as shown in above diagram: - mains power supply - fiber cables to/from g-lec phantom frames - dvi-d from appropriate dvi video source (2) on your control pc, install the latest g-lec software (from http://g-lec.Com/en/software.Html ). It's recommended to insta...
Adjusting the panels (1) make sure everything is properly connected, and dvi is present (all indicator leds at the s-drive must be lit, the s-drive's display should show the correct dvi resolution, and the panels should at least show some random parts of the dvi signal) (2) start the g-lec software ...
(14)in the upload data window, select the options your upload requires: phantom 60 and phantom 30-1 do not understand any gamma command: do not use either 'global gamma' nor 'keep gamma' with those. 'wait answer' tells the software whether it should expect the return line connected. You may uncheck ...
Understanding variable cropping due to data rate limitations, the fiber optic link can transmit only something like 400,000 pixels (exact number depends upon resolution, frequency, and shape). Whereas the s-drive 1 was merely a converter and always converted the entire input signal (including 40 tra...
Example 1 – see text above: 1 panel located at 200x100, variable cropping not activated – no green border around the panel watch the messages: cropping: 200 x 140 variable cropping is not mentioned g-lec vision gmbh s-drive ii quick setup guide page 10
Example 2 – see text above: 1 panel located at 200x100, variable cropping activated – green border around the panel watch the green border around the frame, and the reading at the bottom. Watch the messages: ... Variable cropping mode activated !!! Variable cropping is: 200x100 w:32 h:32 -----------...
Contact, help, support please find useful information, software updates etc. At our website: http://www.G-lec.Com/en/software.Html in case of questions and urgent problems, please write to info@g-lec.Com g-lec and the g-lec logo are registered trademarks of g-lec vision gmbh, karlsbad, germany. Pate...