G-LEC S-Drive II Quick Start Manual - Safety Precautions
Safety Precautions
–
This equipment must be earthed
–
IP 20. Do not expose to rain, moisture, dust or heat (like direct sunlight)
–
No user-serviceable parts inside, do not open.
–
CAUTION: high voltage, possible hazard when unit is open and connected to mains voltage
–
This unit outputs laser radiation: Class 1 FDA and IEC laser safety compliant ('safe under all conditions
of normal use')
S-Drive II Features
–
Wide-range mains voltage (90-240 volts, 50/60Hz). Take care for your local mains connector – direct
power intake is Neutrik PowerCon
–
DVI-D, single link, video input
–
DVI-D, single link, video thru (internal splitter)
–
USB 1.1 for control purposes
–
Fiber optic connectors (SC, 50/125µm) for G-Lec signal (to/from panels)
–
Alphanumeric display to show important data (input resolution; cropping area)
–
Indicator LEDs for mains, DVI, Fiber Sync
–
Input: DVI-D, any resolution up to 1920x1200 pixels, minimum frequency 47 Hz
–
Color space: RGB
–
Auto-sync: the S-Drive II allows for any sync setting (+/+, -/-, +/-, -/+)
–
EDID: S-Drive II sends its own EDID. The data of an optionally connected display is not processed nor
forwarded
–
Fiber output: a selectable rectangle, being cropped out from the input signal. Cropping area is
transparently defined with the G-Lec software. Cropping details are stored in built-in non-volatile
memory.
–
weight: 2.1 kg/4.62 lbs
G-Lec Vision GmbH
S-Drive II Quick Setup Guide
Page 3