G-LEC S-Drive II Quick Start Manual - page 8
(14)In the Upload Data window, select the options your upload requires:
Phantom 60 and Phantom 30-1 do not understand any Gamma command: do not use either
'Global Gamma' nor 'Keep Gamma' with those.
'Wait answer' tells the software whether it should expect the return line connected. You may
uncheck this box in order to perform uploads without return line (this affects the setting in the Show
Serial dialog, see step (6))
In order to update only specific groups in a multi-group setup, use the 'Selective Upload'
dropdown list.
(15)Click 'Upload'. A list with valuable information will run through, ending with the message 'Upload
successful' (hopefully:-) - and your panels toggle back to normal video mode, showing your video
signal in correct position and correct brightness
After uploading, check your S-Drive II display: the cropping reading must match the cropping data
in the software's Main window (see step (12)).
Close the Upload dialog.
(16)Click 'Save Project', to save your setup:
Make a habit of frequently saving your work. Upon upload, all Information is stored in the
frames and the S-Drive only, and there is no way to retrieve it back from there. Furthermore, upon
Exit, the software actually doesn't ask whether you want to save. In other words:
SAVE YOUR WORK OFTEN!!!
(17)Close the software. You may disconnect USB now. Your panels are ready to work.
If you need to edit an existing project, you can load it, edit it, and upload again. Please be
aware that currently the information for whether Variable Cropping is used is not stored in the
project. Make sure to click 'Variable Cropping' again, to see the green border (see step (12)).
Do NOT use the Zoom in the software. Currently there is a bug in the software, and using zoom
might confuse your data. (If you accidentally used the Zoom, zoom out again, and click each group,
move it with the arrow keys by at least 1 pix, upload/save again).
G-Lec Vision GmbH
S-Drive II Quick Setup Guide
Page 8