Gaggenau BM 270 Instruction Manual - page 25
25
Faults
In the event of a malfunction, start by checking the
household fuse. If the problem does not lie with the
electricity supply, inform your dealer or the
appropriate Gaggenau after-sales service.
Please quote the E number and the FD number of your
appliance when contacting the aftersales service. You
can find these numbers on the appliance nameplate.
To ensure electrical safety, only authorised experts
may carry out repairs.
ã
Warning!
Incorrect repairs may cause serious hazards.
Fully disconnect the appliance from the mains before
any maintenance activities (switch off the household
fuse or the switch in the fuse box).
Compensation for any damage arising from failure to
adhere to these instructions cannot be claimed under
warranty.
Error messages
If a fault occurs, an error message appears in the
display.
Touch the touch key next to the = symbol to view
information on the error message.
When you call the after-sales service, you will need to
provide them with the error message and the
appliance model. You will find details of the appliance
model on the nameplate.
Demo mode
If the \ symbol appears in the standby display, the
demo mode is activated. The appliance does not heat
up.
Briefly disconnect the appliance from the mains
(switch off the household fuse or the circuit breaker in
the fuse box). Following this, deactivate the demo
mode in the Basic settings menu within 3 minutes.
Replacing the oven light bulb
It is possible to replace the oven light. Heat-resistant
60 W, 240 V halogen bulbs can be obtained from the
after-sales service or from a specialist retailer.
ã
Risk of electric shock!
Never replace the oven light when the appliance is
switched on. Pull out the mains plug or switch off the
appliance at the circuit breaker in the fuse box.
Note: Always remove the new halogen bulb from the
packaging using a dry cloth. This increases the
service life of the bulb.
Method
Note: You must remove the whole appliance in order
to replace the cooking compartment light. Follow the
installation instructions.
1
Unplug the appliance from the mains or switch off
the circuit breaker in the fuse box.
2
Open the appliance door.
Undo the securing screws on the right and left-
hand side of the oven. Follow the installation
instructions.
3
Carefully lift out the appliance.
4
Undo the screw from the light cover on the outer
left-hand side wall and remove the cover. (Fig. A)
Pull out the halogen light. (Fig. B).
5
Insert the new halogen bulb (Fig. C)
%
$
&