Gaggenau BS 470/471 Instruction Manual - page 33
33
Drying programme
With the drying program, you can dry the cooking
compartment after cleaning or after steaming.
The drying program takes 20 minutes.
Starting the drying program
1
Remove accessories from the cooking
compartment. Wipe out the cooking compartment.
Thoroughly remove residues of cleaner. Close the
appliance door.
2
Set the function selector to S. Select the drying
program with the rotary selector.
3
The j symbol is displayed. Touch ™ to confirm.
4
The drying time of 20 minutes appears. Touch
I
to
start. The drying time elapses on the display. The
lamp in the cooking compartment stays off.
5
A signal sounds after 20 minutes. A message
appears in the display. Touch ™ to confirm.
The drying programme has ended. Allow the appliance
to cool down. Then polish the cooking compartment and
the panel with a soft cloth.
Descaling programme
Regular descaling keeps the cooking compartment in
good condition. The descaling programme descales,
rinses and dries the cooking compartment fully
automatically.
Depending on the type of water and your use of the
appliance, a message on the display will remind you to
run the descaling programme. If necessary (e.g. if there
are traces of limescale in the cooking compartment),
you can run the descaling programme more frequently.
The descaling programme takes 2 hours and 15 minutes
from beginning to end.
You need special descaling cartridges for the descaling
programme. These are available from the after-sales
service or from our online shop (CL S20 040 set with
four descaling cartridges, part number 00311768).
Caution!
Damage to the cooking compartment: Use descaling
cartridges for the descaling programme only. Never
place descaling cartridges in the cooking compartment
when it is hot or heat them up in the cooking
compartment.
Notes
‒
The descaling programme cannot be started until
the appliance has cooled down to below 40 °C.
‒
Remove all accessories from the cooking
compartment before starting the descaling
programme (rack, cookware, core temperature
probe).
‒
The drain filter must remain inserted in the cooking
compartment floor while the descaling programme
is in progress.
‒
The appliance door is locked while the descaling
programme is in progress.
‒
Always allow the descaling programme to run to the
end. The descaling programme cannot be
cancelled.
‒
Depending on the water type and your use of the
appliance, descaling may be still be required even if
you use the water descaling system (special
accessory GF 111 100). A message will appear on
the display to remind you of this.
Drain filter not inserted
The drain filter must remain
inserted in the cooking compart-
ment floor while the cleaning pro-
gramme is in progress.
Power cut
Following a power cut that lasts
longer than 3 minutes, the cleaning
programme will be ended with a
short programme.
Stubborn burnt-on food
residues
Run the cleaning programme again
to remove stubborn food residues.
Possible cause
Solution
'U\LQJSURJUDPPH
_