Gainsborough G+ Series User Manual

Manual is about: Video Entry Box

Summary of G+ Series

  • Page 1

    G+ video entry user guide.

  • Page 2

    Welcome to the easier way to access your home.

  • Page 3

    This guide will show you how to install your g+ video entry box. Contents section 1 overview ............................................................................................................................ 2 g+ camera 2 g+ home port 3 g+ internal display unit: vista model 4 g+ internal d...

  • Page 4

    1 overview, system layout.

  • Page 5

    3 2 section 1 overview overview the g+ video entry allows: • visitors to communicate with occupants of the building from the g+ camera • the occupants of the building to monitor, via a g+ internal display unit, who is at the g+ camera or cctv cameras • the occupants to control access to the building...

  • Page 6

    5 section 1 subsection name 4 section 1 subsection name back 1 2 3 4 room room room room passage privacy menu/set off/save ok next/+ answer intercom monitor g+ internal display unit: vista model 1 indicator light 2 menu item change 3 answer incoming calls / transfer calls to other g+ internal displa...

  • Page 7

    7 6 section 1 overview front 1 2 3 4 room room room room menu/set next/+ monitor answer intercom passage privacy off/save ok 1 menu item change 2 menu navigation 3 room call 4 monitor / select cameras 5 answer incoming calls / transfer calls to other g+ internal display units 6 passage mode for g+ l...

  • Page 8

    9 8 section 1 system layout connections when controlling a g+ lockset / g+ smart boxes system layout 1 2 3 4 room room room room passage privacy menu/set off/save ok next/+ answer intercom monitor 1 2 3 4 room room room room passage privacy menu/set off/save ok next/+ answer intercom monitor 1 2 3 4...

  • Page 9

    2 installation, set up, operation.

  • Page 10

    13 12 section 2 installation installation g+ camera installation step 1: the g+ camera should be installed at eye height as shown below. Step 2: direct sunlight and rain on the camera should be avoided. Section 2 installation g+ internal display unit installation step 1: the g+ internal display unit...

  • Page 11

    15 14 controlling a g+ lockset / smart box from the g+ video entry wiring instructions guidelines take care - electricity kills! Switches, power outlets and other fixed wired products must be installed by a licensed electrical contractor or similarly qualified person. Note: the installer should cons...

  • Page 12

    17 16 section 2 wiring controlling an electric strike from the g+ camera: alternative method note: the installer is responsible for ensuring the compatibility / suitability of electric strikes being connected to the g+ camera. Warning: this method of wiring the electric strike is not secure. Removin...

  • Page 13

    19 section 1 subsection name 18 section 1 subsection name section 2 wiring wiring using cat5e cable section 2 wiring wiring using cat5e cable (continued) 1 2 3 4 room room room room passage privacy menu/set off/save ok next/+ answer intercom monitor 1 2 3 4 room room room room passage privacy menu/s...

  • Page 14

    21 20 section 2 set up set up g+ home port refer to the g+ home port manual for how to program the g+ home port to a g+ lockset or g+ smart box. G+ video entry menu navigation in standby mode, hold the button for 2 seconds to enter the main menu set up interface as follows: press the button to move ...

  • Page 15

    23 22 volume settings the chime, talk, and cctv volumes can be set to high, low or mute. The chimes can be set for each g+ internal display unit. Other settings this menu allows the g+ cameras to be enabled / disabled. Disabling a camera stops a blue screen being shown when cycling through the units...

  • Page 16

    25 24 section 2 set up how to transfer a visitor’s call between g+ internal display units 1 direct transfer: • after answering the call, press the button again and then press the required room number button. Press the button on receiving monitor to answer the call. 2 broadcasting transfer: • after a...

  • Page 17

    27 26 section 2 set up how to make calls between g+ internal display units there are two ways to make calls between g+ internal display units: 1 to call to all g+ internal display units: – press the button, all other receiving g+ internal display units will chime – press the button on a receiving g+...

  • Page 18

    3 general specifications.

  • Page 19

    31 30 section 3 general specifications general specifications g+ camera camera 1/4 inch colour resolution 420 lines view angle 68° wide angle lens min illumination 0 lux night illumination 3 leds (infrared) power dc 12v power consumption 2w size (mm) 98 w x 173 h x 25 d g+ internal display unit – vi...

  • Page 20

    This document contains general installation information only and is in no way to be regarded as a complete and comprehensive guide. Gainsborough hardware industries limited acn 004 792 269 (gainsborough hardware) makes no representation about the content and suitability of this information for any p...

  • Page 21

    Nsw suite 1b, 126 taren point rd taren point nsw 2229 t 02 9524 4855 f 02 9524 5670 qld 433 logan rd stones corner qld 4120 t 07 3394 8323 f 07 3847 5444 wa 12 juna drv malaga wa 6945 t 08 9209 2511 f 08 9209 2611 vic 31–33 alfred st blackburn vic 3130 t 03 9877 1555 f 03 9894 1599 sa 31 lansdowne t...