Gainsborough G+ Series User Manual - page 16
25
24
Section 2
Set up
hOW TO TraNSFEr a VISITOr’S CaLL BETWEEN
G+ INTErNaL DISPLay uNITS
1 Direct Transfer:
• After answering the call, press the
button again and then press
the required room number
button. Press the
button
on receiving monitor to answer the call.
2 Broadcasting Transfer:
• After answering the call, press the
button again. You can now talk
to all other G+ Internal Display Units. Any of the other G+ Internal
Display Units can take the call by pressing their
button. The other
units will hang up automatically.
hOW TO aDjuST BrIGhTNESS/CONTraST/COLOur
While there is an image on the screen:
• Press and hold the
button for 2 seconds, the screen will show the
Brightness scale, then use the
button to adjust the Brightness.
• Press the
button again, while the Brightness scale is still visible, to
adjust the Contrast, and repeat for Colour.
• Press the
button to save and return to the Main Menu. Press the
button again to turn off the screen and exit.
Section 2
Set up
hOW TO mONITOr ThE CamEraS
The Cameras are accessed by pressing the
button.
Pressing the
button for the first time will display the image from the
1st G+ Camera.
Pressing the
button again will cycle the display through the
Cameras in the following order:
• 2nd G+ Camera
• 1st CCTV Camera
• 2nd CCTV Camera
• 3rd CCTV Camera
• 4th CCTV Camera
• Back to the 1st G+ Camera
If there is a call from a G+ Camera while viewing images from the other
Cameras:
• The screen will change to the G+ Camera image.
– Press the
button to answer the call.
– Press the
button to end the call.
• The screen will then automatically return to the previous Camera image.
NOTE:
• Disabling a CCTV Camera in the set up menu will remove it from the above
loop.
• Images from Cameras 1 and 2 can only be viewed for 30 seconds. The
images from the CCTV Cameras will stay on until the screen is turned off.