Galanz XQG60-A708E Service Manual - page 14
13
Heater
⒉ Loosen the M6 bolt from heater. please do not
compete loosen the bolt.(picture19)
②Pull out the heater
Attention
Ensure the heater has put into the clip
19
Switch component and door lock
①Remove the front cover real ring spring (photo 7)
⒉
Remove the 2 bolt from the fixed door lock (photo
20)
③ Take off the door lock from the wiring harness
connector
20
Drying Thermostat ( model with drying features)
① Open top cover, control panel board, bottom
dam-board and front cover
② Remove eight bolt from the top bracing sheet and
take off the front top bracing sheet (photo 21)
③Remove the bolt from the outer box.(photo 22)
④Then take off the drying thermostat
21
22
Drying motor(model with drying features)
② Remove the top cover
② Take out the drying motor plug wire
Remove the fixed bolt from the drying motor (photo 23)
23
Drying heating pipe(model with drying features)
② Remove top cover
② Take off the plug wire from drying motor and drying
heating pipe
③Remove the fixed bolt from drying motor and drying
heating pipe. (picture 4)
24
6.1.2 Inlet box AS