Galaxy Audio AS-1400 User Manual - System Setup
1. Power On:
Hold the power button for 3 seconds to power on the transmitter.
Display will light up. Hold for another 3 seconds to turn off.
Programming the Transmitter
System Setup
2. Frequency Group and Channel Selection:
Press the “SET” button. The display will flash “GROUP”. Press
or to select a suitable frequency group number as shown in Fig. 2a.
Press “SET” again. The display will flash “CHANNEL”. Press
or to select a suitable channel as shown in Fig 2b.
Note: When using multiple systems, for optimum results, set all of the
systems to the same group number and select a different channel
number for each system in that group.
3. Stereo/Mono Input Mode Selection:
Press the “SET” button 3 times, the “STEREO” will flash. Press
or button to select Stereo or Mono, then press set again to set
the selected mode as shown in Fig. 3.
4. Locking Control Selection:
Press the “SET” button 4 times, the “ ” will light up. Press
or button to select Lock or Unlock status as shown in Fig. 4.
R
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 1
Fig. 2a
R
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 2b
R
MHz
GROUP
CHANNEL
STEREO
MONO
R
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 3
R
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 4
6