Galaxy Audio AS-1400 User Manual - System Setup
System Setup
1. Power On:
Turn the Body Pack on by turning the volume control clock-wise.
The LCD display will light up as shown in Fig 1.
Programming the Body Pack Receiver
2. Frequency Group and Channel Selection:
Press the “SET” button. The display will flash “GROUP”. Press
or to select a suitable frequency group number as shown in Fig. 2a.
Press “SET” again. The display will flash “CHANNEL”. Press
or to select a suitable channel as shown in Fig 2b. Make certain
that the transmitter and receiver are on the same frequency.
Note: When using multiple systems, for optimum results, set all of the
systems to the same group number and select a different channel
number for each system in that group.
5. RF Signal Indication:
The receiver has 5 levels of RF signal indication as shown in Fig. 5.
4. Locking Control Selection:
Press the “SET” button 4 times until “ ” lights up. Press
or button to select Lock or Unlock status as shown in Fig. 4.
Fig. 1
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 2a
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 2b
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 4
MHz
GROUP
CHANNEL
STEREO
MONO
Fig. 5
MHz
GROUP
CHANNEL
STEREO
MONO
7
System Setup
(Cont.)
Fig. 6
MHz
GROUP
CHANNEL
STEREO
MONO
6. Pan Control:
Use the arrow keys to adjust the left/right balance as shown in Fig. 6.
balance to left
balance to right
3. Stereo/Mono Select:
Press the “SET” button 3 times. The stereo/mono display will flash.
Press the or buttons to select desired mode as shown in Fig. 3.
Fig. 3
MHz
GROUP
CHANNEL
STEREO
MONO