Game Winner FSGWBG1000 Assembly Manual - Grill Maintenance
Grill Maintenance
Grill Maintenance
• Clean and inspect pressure regulator and hose assembly prior to use.
• Allow grill to cool before cleaning. Frequency of cleaning is determined by how
often grill is used.
• DO NOT use self-cleaning oven to clean any grill part. Extreme heat would remove
any chrome plating and cause premature rusting.
• Meal drippings will solidify in bottom of grill after a few uses. This residue should
be removed regularly. Failure to do so could cause overflow at bottom vent openings
and increase the chance of a grease fire.
• When cleaning grill, cover work area with newspaper. Open grill lid and remove
cooking grate. Loosen residue with scraper or putty knife. Wipe away loosened
residue with paper towels.
• Inside surface of grill may be cleaned with a strong solution of detergent and water
applied with a scrub brush. Cooking grate may be cleaned with a brass wire brush.
Thoroughly rinse grill with water and allow to completely air-dry before using again.
• Place cooking grate and lid onto grill.
• Check and clean burner/venturi tubes for insects and insect nests. A clogged tube
can lead to a fire beneath the appliance.
• Do not obstruct the flow of combustion and ventilation air.
Burner Cleaning
Before cleaning, make sure the gas supply and control knobs are in the “OFF”
position and the burners have cooled.
Orifice spud (A)
To remove the main burners for cleaning:
1. Open lid. Remove the cooking grate and
flame tamer.
2. Remove the screws and ignition electrode
wire, lift the burner out of the firebox to clean
the grill burners.
3. Clean the exterior of the burner with a wire
brush. Use a metal scraper for stubbed stains
or debris.
4. Clear clogged ports with straightened paper clip. Never use a wooden toothpick as
it may break off and clog the port.
5. Check and clean burner / venturi tubes for insects and insect nests. A clogged tube
can lead to a fire beneath and behind the main control panel.
Screw
Burner
SC2000304-OG-00
– ENG P.25 20131026-V1