Game Winner FSGWBG1000 Assembly Manual - Before Installing:
USE OF LP GAS CYLINDER AND INSTALLATION
BEFORE INSTALLING:
LP GAS CYLINDER
•
The installation must conform with local codes or, in the absence of local codes,with
the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling of
Liquefied Petroleum Gases, ANSI/NFPA 58; or Natural Gas and Propane
Installation Code, CSA B149.1;Propane Storage and Handling, CSA B149.2; or the
Standard for Recreational Vehicles, ANSI A119.2/NFPA 1192; and Recreational
Vehicle Code, CSA Z240 RV Series, as applicable.
•
The LP-gas supply cylinder to be used must be constructed and marked in
accordance with the specifications for LP-gas cylinders of the US Department of
Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339,
Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.
•
This appliance is designed to operate with a one pound
7.75” or 10.6” high disposable / 16.4 oz. or 14.1 oz.
propane gas cylinder (DOT 39 Cylinder)
•
Do not attempt to refill any disposable propane gas
cylinders.
•
The cylinder must be installed, transported and stored
in an upright position and should not be dropped or
handled roughly.
•
When the appliance is to be stored indoors, the propane
gas cylinder must be disconnected from the appliance.
•
When the propane gas cylinder is connected to the
appliance, both must be stored outdoors in a well-ventilated space.
•
The propane gas cylinder should never be transported or stored where
temperatures can reach 51.C (124.F)
•
Cylinders must be stored outdoors out of the reach of children and must not be
stored in a building, garage, or any other enclosed area.
•
The propane gas cylinder supply system must be arranged for vapor withdrawal.
•
Disconnect the gas propane cylinder when not in use.
CONNECT THE PROPANE GAS CYLINDER
Only cylinders marked “propane” may be used.
Note: Some 1lb cylinders may form frost when
near empty.
1.
Make sure the control knob is in OFF position.
2.
Lubricate the threads of the regulator with
petroleum jelly if necessary. Line up threads
on LP gas cylinder with regulator.
3.
Insert and rotate LP gas cylinder clockwise
until they fit snugly together. HAND TIGHTEN
ONLY. Be careful not to cross threads when
screwing in the cylinder. Test for leaks,
see “Leak Test” Section.
Warnings
SC2000304-OG-00
– ENG P.6 20131026-V1