Gamma Scale Sartorius PMA 35D-X Nstallation And Operating Instructions - page 8
8
Accessing the Menu
Press e (2) to turn off the scale. Press e again to turn the scale
back on; briefly press the = key (4) during the automatic self-test.
“I “ is now displayed.
Set the desired code as follows:
Press = (4) until the desired number is displayed.
Press w (6); the middle number appears. Press = (4) until the
desired number is displayed. Press w (6); the third digit appears.
Press (= (4) until the desired number is displayed. Then press w
(6) for 2 seconds until “o” appears. This symbol indicates that the
new code has been set. Hold down = (4) for 2 seconds until an
automatic self-test is run. Then release this key. The new code is
now saved.
Important Codes:
Adaptation to ambient conditions
You can adapt the scale to the ambient conditions that prevail at the
place of installation.
Code
Very stable conditions
1 1 1
Stable conditions (factory setting)
1 1 2°
Unstable conditions
1 1 3
Very unstable conditions
1 1 4
To obtain a detailed list of the menu codes, please ask your nearest
Sartorius office, dealer or paint supplier.
Care and Maintenance
Cleaning
Use only naphtha or alcohol to clean the scale.
G
Do not wash down the scale with water or dry it with compressed air.
Safety Inspection
G
If there is any indication that safe operation of the scale with the AC adapter is no longer
warranted, turn off the power and disconnect the equipment from AC power immediately. Lock the
equipment in a secure place to ensure that it cannot be used for the time being.
In this case, notify your Sartorius office, dealer or paint supplier. Only service technicians who are
authorized by Sartorius and have access to the required maintenance manuals are allowed to perform
maintenance and repair work on the equipment.
Safe operation of the equipment is no longer ensured when:
- there is visible damage to the equipment
- the equipment no longer functions properly.
Always unplug the scale before connecting peripheral equipment. You can choose the 9-pin or 25-pin
data output port.