Ganz ZN-DNT352XE SERIES Installation Manual - page 15
01A.01
15
7. When the dialog box appears to request user name and password, enter the default
value for the administrator account (case-sensitive) as below:
ID: root
Password: pass
8. Refresh the page and check if the live image is displayed successfully.
6.2.2.View video using IP address
View the live video on a web page using your IP device and its IP address. To have the correct
IP address ready and use it on a web page:
1. Convert a MAC address to an IP address or check the IP address on the IPAdminTool. Refer to
Appendix (D). Hexadecimal-Decimal Conversion Table.
(The MAC address is attached on the side or bottom of the device.)
2. Open a web browser and enter the IP address of the device.
3. Click Continue to this website on the Security Certificate Alert page.
4. Click pop-up blocked and install the ActiveX control as below. You need to install the ActiveX
for displaying the images.
5. Wait for a few seconds while the web page loads. The live video is displayed.
6.3. Reset
1. While the device is in use, press the Reset button.
2. Wait for the system to reboot.
6.4. Factory Default
1. Press reset button and hold.
2. Release the Reset button after 5 seconds until LED blinks.
3. Wait for the system to reboot.
The factory default settings can be inferred as follows:
IP address:
192.168.xx.yy
Network mask:
255.255.0.0
Gateway:
192.168.0.1
User ID:
root
Password:
pass
MAC address = 00-13-23-01-14-B1 → IP address = 192.168.20.177
Convert the Hexadecimal number to Decimal number.
ZN-DNT352XE Installation Guide