Ganz ZN-DNT352XE SERIES Installation Manual - page 9
01A.01
9
4.2. Setting the Lens Position
Set the lens position and adjust the zoom and focus by performing procedures as below.
1) Remove the dome cover.
2) Adjust the lens to the desired position by manually moving its body in the following
directions.
3) Connect to the web page of the device to see its real-time image. Refer to step 6.
Configuration for details about using its web page.
5) Unscrew the focus puller by turning it counterclockwise. Move it left or right and adjust the
image focus. After the setting, tighten the focus puller again by turning it clockwise.
4.3. Setting the Image Attribute
You can set the image attribute of camera through the webpage.
The menu of image attribute can be seen under Setup > Video & Audio > Camera. Brightness,
contrast, saturation and sharpness can be adjusted.
C. Tilt the lens
A. Rotate the lens
B. Pan the lens bottom holder
Zoom puller
Focus puller
4) Unscrew the zoom puller by
turning it counterclockwise. Move it
left or right and set the lens to the
desired zoom position. After the
setting, tighten the zoom puller again
by turning it clockwise.
ZN-DNT352XE Installation Guide