Gardeline 2 in 1 Petrol Grass Trimmer/Brush Cutter Operating Instructions & User Manual - Instructions
26
Instructions
5
GB
IRE
MODEL: GLBC 43
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
Preventing recoil
When you work with the blade, there is a risk of recoil if it strikes solid objects
(tree trunks, branches, tree stumps, stones or the like). This will throw the
equipment backwards in the direction opposite to the rotation of the cutting tool.
This can cause you to lose control of the equipment. Do not use the blade near
fences, metal posts, boundary stones or foundations. For cutting slender wood
growth, position the equipment as shown in Fig. 9f in order to prevent recoil.
Maintenance and ordering of spare parts
Always switch off the equipment and disconnect the spark plug boot (36) before
carrying out any maintenance work.
Maintenance of the air filter
Soiled air filters reduce the engine output by supplying too little air to the
carburettor. Regular checks are therefore essential. The air filter (35) should be
checked after every 25 hours of use and cleaned if necessary. If the air contains
a lot of dust, the air filter should be checked more frequently.
1
Remove the cover from the air filter housing (Fig. 10a/Item 8)
2
Remove the air filter (Fig. 10b/10c)
3
Clean the air filter by tapping it or blowing it out (with compressed air).
4
Assemble in reverse order.
IMPORTANT!
Never clean the air filter with petrol or inflammable solvents.
Maintenance of the spark plug
Electrode gap = 0.6 mm (distance between the electrodes and between which the
ignition spark is created). Tighten the spark plug to 12 to 15 Nm using a torque
wrench (available from your dealer). Check the spark plug for dirt and grime
after 10 hours of operation and if necessary clean it with a copper wire brush.
Thereafter service the spark plug after every 50 hours of operation.
1
Dismantle the protective cap (Fig. 10c/Item 31) using a screwdriver.
2
Pull off the spark plug boot (Fig. 11a/Item 36).
3
Remove the spark plug (Fig. 11b) with the supplied spark plug wrench (27).
4
Assemble in reverse order.