Garden Trax Y2007 Instructions Manual - page 15
15
ADJUSTING WHEELS & DRAG STAKE
The wheels on the mini cul vator can be adjusted into two height po ons (See Figure 4)
1.
To adjust the wheels, pull the detent pin out of the rear mounted plas parts mount hole
2.
Turn the rear mounted p
parts 180 degrees and then put the rear mounted p
parts into the rear hanging
board and then replace the detent pin
The Drag Stake is used to regulate the depth of cu v on and also to help maintain direc on and keep the mini
cul vator from leaping forward during op
on. Resistance to the forward mo on is achieved when the Drag Stake is
set to its lowest po on allowing deeper cul v on (See Figure 5)
1.
Pull the pin out of the Drag Stake mount hole
2.
Posi on the Drag Stake so that the pointed end of the stake is directed downward
3.
Once desired depth is reached, reinsert the Drag Stake pin back into the hole
Always make sure the engine is o
ff
whenever maintenance or cleaning is being done on the unit. Make sure the unit is
o
ff
when using tools and moving the unit from one loc on to the other by any means other than its own power
Never work on excessively steep slopes
Always inspect the area to be cul vated and make sure it is free of any objects that could be thrown out by the unit
This device should only be operated by suitably trained adult individuals who have read the en
instru on manual
Always wear quality safety shoes when opera ng this device
FIGURE 4
FIGURE 5
High Position
Low Position
Drag Stake Pointed Tip
Detent Pin
MODEL Y2007
MINI CULTIVATOR AND DETHATHER