Gardena 19080 Operating Instructions Manual - 8. Technical Data
Problem
Possible Cause
Remedy
ErrorLED flashes 4 times.
The pump switches off during
on-going operation after 60 minutes
or 2 minutes.
Leakage warning is activated
Leak on pressure side
(e. g. dripping tap).
v
Eliminate any leak on the
pressure side.
Exceeded maximum duration
(60 mins.) of the low quantity
programme.
v
When using the low quantity
programme, shorten the
watering duration or interrupt
for 5 minutes.
v
Increase water consumption.
Check valve is blocked.
v
Clean the check valve
(see To clean the check valve).
Flow Sensor signal is faulty
Flow Sensor is blocked.
v
Clean the flow sensor
(see To clean the flow sensor).
Pump does not start or stops
suddenly during operation
Mains plug is disconnected.
v
Connect the mains plug.
Power failure.
v
Check the fuse and the cables.
FI was triggered because
a residual current was detected.
v
Disconnect the pump and con-
tact the GARDENA Service.
Electrical interruption.
v
Disconnect the pump and con-
tact the GARDENA Service.
Repairs:
Note:
For any other malfunctions please contact the GARDENA service
department. Repairs must only be done by GARDENA service
departments or specialist dealers approved by GARDENA.
8. TECHNICAL DATA
smart Pressure Pump
Art. 19080
Rated Power /
Standby consumption
1300 W / 1.5 W
Mains voltage
230 V
Mains frequency
50 Hz
Connection cable length
1.5 m (H07RN-F)
Radio frequency range
863 – 870 MHz
Maximum transmission power 25 mW
Free field radio range
approx. 100 m
Max. delivery capacity
5000 l/h
Max. pressure
5 bar
Max. delivery head
50 m
Max. suction height
8 m
Cutin pressure
2.0 – 2.8 ± 0.2 bar
Permitted internal pressure
(delivery side)
6 bar
25
GB