Gardena 7883 Operating Instructions Manual - 3. Assembly
13
GB
B
Installing the set as a
stream pump :
3. Assembly
v To assemble the UVC lamp see 7. Troubleshooting
“Replacing the UVC bulb”.
The stepped nipple (½
" / ¾" )
6
can be used for connection,
for example, to a gargoyle.
If the side outlet is not needed the
6
sealing cap
8
can be
screwed in instead of the step nipple.
1. Screw the T-joint
7
onto the connection
1
.
2. Screw the stepped nipple
6
onto the side outlet of the
T-piece
7
.
3. Screw the ball joint
2
onto the T-piece
7
.
4. Push the nozzle tube
3
onto the telescopic handle
b
up to
the sleeve
a
.
5. Snap the nozzle tube
3
into the ball joint
2
.
6. Screw required fountain insert
4
a) / b) / c) / d) fully into the
nozzle tube
3
.
a) Cascade b) Water Bell c) Fleur-de-Lis d) Water Jets
The stepped nipple (½
" / ¾" )
6
can be used for connection, for
example, to a stream or source stone.
1. Screw the T-joint
7
onto the connection
1
.
2. Screw the stepped nipple
6
onto the side outlet of the
T-piece
7
.
3. Screw the cap
8
onto the T-piece
7
.
The GARDENA Pond Aerator Art. 7942 / 7943 can be con-
nected to increase the oxygen content. The aragonite and
the hose are supplied with the pond aerator.
1. Remove the filter housing (see 6. Maintenance).
2. Connect the aragonite
9
with a piece of hose to the air con-
nection piece
0
.
3. Put the aragonite
9
between the filter stone bags ensuring
that the hose is not kinked.
4. Connect the pond aerator hose
A
to the air connection piece
0
from the outside.
Assembling the UVC bulb :
A
Installing the set as a
fountain pump :
Connecting the pond aerator
(available as an option) :
7
1
8
6
3
2
1
4
a
b
7
6
9
0
A
9
A