Gardena 884 Operating Instructions Manual - 6. Troubleshooting
Clean the filter
in the sprayer handle :
Cleaning the pump :
C
B
D
A
O
F
P
Q
S
G
N
R
GB
13
6. Troubleshooting
1. Unscrew the union nut
B
and pull the hose
C
with filter
D
out of the sprayer handle
A
.
2. Rinse the filter
D
under running water.
3. Reattach the sprayer handle (see 3. Assembly “Attaching the
sprayer handle to the hose”).
If the pump does not provide pressure after cleaning your Back-
pack Sprayer you must also clean the pump.
1. Push out the locking ring
N
(using a screwdriver, for example)
and pull the joint rod
O
out of the pump
F
.
2. Unscrew the union ring
P
and pull out the pump
F
.
3. Inspect the pump O-ring
S
and install a new O-ring if neces-
sary.
4. Pull out the inner part of the pump
R
and the gasket
S
.
5. Clean all pump parts and gaskets with water (and detergent).
6. Reassemble the pump in the reverse order.
When assembling the pump ensure that the pump gaskets are
seated properly after installation and are not squashed.
Fault Possible Cause Remedy
Pump does not provide
Valve in the tank cap blocked.
v
Clean the tank cap.
pressure
Hose connections at the
v
Tighten the hose connec-
pump and sprayer handle tions at the pump and
are leaking. sprayer handle.
Pump O-ring
Q
leaking at the
v
Clean the pump and check
pump. the pump O-ring
Q
at the
pump. Install a new O-ring
if necessary.
Backpack Sprayer does not
Nozzle blocked.
v
Clean the nozzle.
spray although there is
Filter
D
in sprayer handle
v
Clean the filter in the
sufficient pressure or
blocked. sprayer handle.
sprays with poor spray jet
Tank is difficult to open
Pressure in tank too low
v
Clean the tank cap
G
.
because the valve in the tank
cap
G
is blocked.
A
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.