Gardena AccuCut 400 Li Operating instructions manual - 9. Accessories
19
GB
Only use original GARDENA Spare Blades. Spare blades
are available from your GARDENA dealer or direct from
GARDENA Service.
•
GARDENA Spare Blades for Turbotrimmer
Art. No. 5368
AccuCut 400 Li / AccuCut 450 Li
Remove blade :
1. Turn Trimmer round and place on rubber pad of handle.
2. Press end of blade down slightly
(A)
, slide blade
T
inside
through blade carrier
S
(B)
and pull out.
Fit blade :
v
Slide new blade
T
from inside through slot in metal of blade
carrier
S
until it snaps into place.
When the new blade is correctly inserted, it can be moved
more easily.
Fault Possible
cause
Remedy
The Trimmer is not cutting
Blade worn or too short.
v
Replace blade.
cleanly or not cutting at all
Blade broken off.
v
Replace blade.
Battery is flat.
v
Charge battery.
Charging indicator lamp does
Battery charger or charging cable
v
Plug in battery charger and
not light up
not plugged in properly.
charging cable properly.
Charging indicator lamp
A fault has occurred.
v
Unplug and reinsert
flashes for more than
charging cable.
The fault
1 hour
will be reset.
If this does not eliminate the fault, please contact
GARDENA Service.
The battery can no longer
Battery is defective.
v
Replace the battery
be charged
(Art. No. 8839).
Only the original GARDENA Replacement Battery 18 V
(Art. No. 8839) may be used. This can be obtained from your
GARDENA dealer or directly from GARDENA Service.
A
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
9. Accessories
GARDENA Spare Blades
Art. No. 5368
GARDENA Replacement Battery
Art. No. 8839
GARDENA Additional wheel
for AccuCut 400 Li
Art. No. 5310
T
S
Replacing blades :
www.devicemanuals.eu