Gardena AccuCut Li 9850 Operation Instructions Manual - 2. Installation
2. INSTALLATION
Initial Operation:
1
2
DANGER! Risk of physical injury!
Cut injury when the product starts accidentally.
v Before you initially operate the product, make sure that
the protective cover
1
is slid over the blade
2
.
To charge the battery:
The battery should be fully charged before using for the first time.
Charging time (see 7. TECHNICAL DATA).
The lithium-ion battery can be re-charged in any state of charge,
and the charging process can be interrupted at any time without
damaging the battery (no memory effect).
The product cannot be started during charging.
3
4
5
WARNING!
Incorrect mains voltage damages batteries and the
battery charger.
v
Ensure the correct mains voltage.
1. Connect charging cable
3
to the jack
4
of the Battery Shear.
2. Connect battery charger
5
to an electrical socket.
During charging, the jack
4
flashes green. The battery is charged.
When the jack
4
lights up green, the battery is fully charged.
Check the charge status regularly while charging.
3. First pull the charging cable
3
out of the jack
4
and then unplug
the battery charger from the electrical socket.
When there is a sharp fall in the power of the battery, the product
switches off and the battery needs to be charged.
3. OPERATION
To start the Grass Shear:
7
6
DANGER! Risk of physical injury!
Risk of injury if the product does not stop when you
release the start button.
v
Do not bypass the safety devices or switches. For example
do not attach the starting lock-out
6
or start button
7
to
the handle.
13
EN