Gardena AccuCut Li 9850 Operation Instructions Manual - 6. Troubleshooting
Disposal:
(in accordance with
RL2012/19/EC)
8
The product must not be added to usual household waste.
Refer to local environmental laws for discarding.
The product contains lithium-ion cells that should not be discarded
with normal household waste at the end of their life.
Please return the lithium-ion cells to your GARDENA dealer or
dispose of them properly at a public recycling centre.
1. Discharge lithium-ion cells
8
completely.
2. Remove lithium-ion cells
8
from the product.
3. Dispose of lithium-ion cells
8
properly.
6. TROUBLESHOOTING
1
2
DANGER! Risk of physical injury!
Cut injury when the product starts accidentally.
v
Before you troubleshoot the product, make sure that the
protective cover
1
is slid over the blade
2
.
To change the blade:
2
w
q
0
9
Only an original GARDENA blade is allowed to be used.
A new blade can be ordered by the GARDENA Service.
1. Push the button
9
and slide the lid
0
downwards.
2. Remove the blade
2
.
3. If necessary clean the transmission chamber and lubricate the
excentric drive
q
with some acid-free grease (Vaseline).
4. Turn the excentric drive
q
downwards.
5. Pull the crank
w
on the back side of the blade
2
in the middle.
6. Place the new blade
2
on the motor product in such a way that
the excentric drive
q
is inserted in the crank
w
.
7. Slide the lid
0
upwards until it makes a click.
Problem
Possible Cause
Remedy
The jack flashes red
while charging
Allowed battery temperature
was exceeded.
v
Let the battery cool down.
Restart the charging.
Runtime too low
Blade soiled.
v
Clean and lubricate scissor
blade in accordance with the
maintenance instructions.
15
EN