Gardena SmallCut 300/23 Operation Instructions Manual - 5. Storage
5. STORAGE
To put into storage:
The unit must be stowed away from children.
1. Disconnect the mains cable.
2. Clean the unit (see 4. MAINTENANCE).
3. Stowe the unit in a dry area where it has protection from frost.
Recommendation:
The unit can be hung up by the handle. The cutting head is not put
under too much strain if the unit is stowed hanging up.
Disposal:
(in accordance with
RL2012/19/EC)
The unit must not be added to usual household waste.
Refer to local environmental laws for discarding.
v
Important: Make sure that the unit is discarded through your
municipal recycling collection centre.
6. TROUBLESHOOTING
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v
Before you troubleshoot the unit, make sure that the
mains cable is disconnected.
To pull the cutting filament
out of the filament cassette:
z
t
t
5
z
If a cutting filament is pulled into the filament cassette you can pull it
out again with the instructions below.
1. Remove the filament cassette
t
with the instructions under
4. MAINENANCE “To replace the filament cassette”.
2. Push together the plastic ring
z
on the filament cassette
t
between your thumb and index finger.
3. Pull the plastic ring
z
over the side part of the filament cassette
(if necessary, use a screwdriver).
4. You can at this time get the cutting filament that was pulled into
the filament cassette.
5. Unwind the cutting filament
5
by approx. 15 cm and put it through
the eye of the plastic ring
z
(if necessary, loosen the welded
cutting filament beforehand using a screwdriver, and unwind and
wind fully).
6. Pull the plastic ring
z
onto the filament cassette
t
.
7. Install the filament cassette
t
with the instructions under
4. MAINTENANCE “To replace the filament cassette”.
8
GB