Gardenline 50714 User Manual - Assembly
S
U
A
1800 909 909
www.powertoolsupport.com email: help@powertoolsupport.com 11/2015
AFTER SALES SUPPORT
50714
11
Assembly
Preparation of the Blower Vac prior to use
The petrol blower vac requires some assembly prior to use. This includes joining of
the vac tubes, joining of the blower tubes, and depending if the tool is to be used
for blowing or vacuuming, fitting of the tube assembly to the housing and fitting
the collection bag assembly to the housing. A medium size phillips screw driver
(not supplied) is required to join the two halves of the vac tubes (10/12) and the
two halves of the blow tubes (5/6).
Setting up for use as a Blower.
IMPORTANT.
Blower tube installation affects both blower balance and
performance. Both tube and nozzle must be screwed together.
WARNING.
Danger from rotating impeller!
Stop the engine before installing or removing the blower tubes. Never perform
any maintenance or assembly procedures on this machine while the engine is
running.
Attaching the Blower Tube
1. Place the blower upright on the ground
or on a sturdy work surface.
2. Push the blower tube nozzle tube (6) over
the lower blow tube (5), lining up the
locking pins. (Fig A)
3. Rotate the blow tube nozzle (6) clockwise
on the lower blow tube (5) locking it into
place. (Fig B)
4. Lock the tubes together using the
2 screws provided. (Fig C)
5. Remove the 2 x toolfree blower lock
knobs (23) from the discharge port (22),
and then align and push the assembled
blower tube assembly over the discharge
port (22) on the blower outlet and rotate until it locks in place and the screw holes
can be seen. (Fig D)
Getting Started
4
B.
D.
A.
C.