Gardenline 50714 User Manual - Fitting The Collection Bag

S 

U 

A 

1800 909 909 

www.powertoolsupport.com      email: help@powertoolsupport.com  11/2015

AFTER SALES SUPPORT 

50714

13

Fitting the Collection Bag

 WARNING 

 Never operate the vacuum without collection bag attached.  

Serious personal injury could be the result if the blower vac is used without the 

bag fitted. 

 IMPORTANT 

 Before using this appliance as a vacuum, ensure the correct vacuum 

tubes are in position as per the instructions on the previous page, and the 

collection bag zip is done up before fitting.

 Note. 

 Always make sure the collection bag (11) zipper is closed when the vacuum 

function is in use.  

For use as a vacuum, the collection bag (11) must be fitted. 

The collection bag (11) fits on to the discharge port (22) of the 

blower vac housing, where the blow tubes are fitted when 

used in blowing operation. If the blow tubes are fitted, these 

need to be removed. Remove the two toolfree screws, rotate 

the tube as far as possible and then pull the tube off the 

blower. (Fig N)

1. Align the collection bag tube (8) to the 

outlet of the vac. Push the collection bag 

tube (8) onto the outlet housing as far as 

possible. (Fig O).

2. Rotate the tube until the retaining holes 

align. Check the orientation of the tube to 

ensure the tube is pointing downward and 

NOT upward. (Fig P).  If upward rotate the 

tube in the reverse direction to assembly, and remove from 

vac.  Turn the tube 180° and refit. Again, check the orientation 

of the tube (8) with the pic.

3. Fit the two toolfree screws to hold the collection tube in place. 

(Fig Q)

 Note. 

  If your collection bag becomes worn, replacement bags 

are available for purchase.  Please refer to page 23 for further 

detail.

 Note. 

 To remove the collection bag, follow the above instructions in reverse.

Instructions

5

N.

P.

Q.

O.