Gardenline 50714 User Manual - Instructions
S
U
A
1800 909 909
www.powertoolsupport.com email: help@powertoolsupport.com 11/2015
AFTER SALES SUPPORT
50714
16
Instructions
5
• Mix only enough fuel for your immediate needs. If fuel must be stored longer
than 30 days, it should first be treated with a stabilizer or similar product.
Operation
During operation of the blower it is recommended to wear eye protection, a dust
mask, and full hearing protection.
Choke control
If the engine is cold you will need to use the choke control.
Start position (choke closed).
Run position (choke open).
Starting the Blower
To start the engine, proceed as follows:
1. Press the primer (13) 5 to 10 times or until
there are no air bubbles are visible in the
fuel discharge line. (Fig U)
Note.
This is not necessary if the engine
is warm.
2. If the engine is cold, move the choke lever
(red) (16) upwards closed. (Fig V)
Note.
Again this is not necessary if the engine is warm.
3. Press the I symbol on the On / Off switch (2) to turn the ignition ON.
4. Place the blower vac on the ground and hold the blower vac handle firmly with
your left hand.
5. Pull the recoil starter (18) until the engine
sounds like it wants to run or starts.
(Fig W)
6. Slowly move the choke lever (red) (16)
halfway down. If the motor is not running
re try to start in the half way choke position.
(Fig X)
7. Allow the motor to run for approximately 20 sec in the half choke position and
then slowly move to the full run position.
8. Allow the engine to run for 10 seconds to let it warm up.
U.
V.
X.
W.