1. DL manuals
  2. Gardenline
  3. Trimmer
  4. Hedge Trimmer
  5. User Manual

Gardenline Hedge Trimmer User Manual

Manual is about: 26cc 2-Stroke Petrol Hedge Trimmer

Summary of Hedge Trimmer

  • Page 1

    26cc 2-stroke petrol hedge trimmer user guide after sales support model: htks26 product code: 43671 11/2015 year warranty 2 1800 909 909 www.Powertoolsupport.Com aus after sales support now you have purchased a gardenline ® product you can rest assured in the knowledge that as well as your 3 year pa...

  • Page 2: Contents

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 2 contents 03 introduction 03 intended use of the 26cc hedge trimmer 03 environmental protection 03 what your 3 year warranty means 04 description of symbols 05 specifications 06 safety ins...

  • Page 3: Introduction

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 3 introduction your new gardenline ® hedge trimmer will more than satisfy your expectations. It has been manufactured under stringent gardenline ® quality standards to meet superior perform...

  • Page 4: Description of Symbols

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 4 description of symbols the rating plate on your tool, and instructions within this manual may show symbols. These represent important information about the product or instructions on its ...

  • Page 5: Specifications

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 5 2 general information & safety instructions specifications engine: 26cc, 2 stroke idling engine speed: 3000min -1 full engine speed: 9000min -1 blade cutting length: 510mm bar length: 633...

  • Page 6: Safety Instructions

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 6 2 safety instructions warning read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “pow...

  • Page 7

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 7 2 • do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. • dress properly. Do not wear loose clothing or...

  • Page 8

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 8 2 general information & safety instructions additional safety rules for petrol hedge trimmers • do not operate in a hazardous location. Such areas include where there is a risk of explosi...

  • Page 9

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 9 2 general information & safety instructions • ensure the hedge trimmer is switched off and is cool before cleaning and maintenance. • if you are interrupted when operating the trimmer, sw...

  • Page 10: Parts List

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 10 3 parts list 4 5 8 15 10 14 11 1 2 3 7 9 13 12 16 17 18 21 19 1. Blades 2. Blunt plate 3. Protective guard 4. Silencer cover 5. Spark plug cover 6. Spark plug (not shown) 7. Front handle...

  • Page 11: Getting Started

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 11 getting started 3 unpacking due to modern mass production techniques, it is unlikely that your petrol hedge trimmer is faulty or that a part is missing. If you find anything wrong, do no...

  • Page 12: Fuelling

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 12 fuelling use fresh unleaded fuel mixed with 2-stroke air-cooled engine oil (40:1) for best results. Use mixing ratios in section fuel mixing table below. Warning. Never use straight fuel...

  • Page 13: Filling The Tank

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 13 filling the tank warning. Always shut off the engine before fuelling. Never add fuel to a machine with a running or hot engine. Move at least 9 m (30 ft.) away from the refuelling site b...

  • Page 14: Starting A Cold Engine

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 14 starting a cold engine caution. Ensure the blade cover (22) is removed before attempting to start the hedge trimmer. Note. Ensure the hedge trimmer has been filled with the relevant fuel...

  • Page 15: Operating Instructions

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 15 operating instructions 5 7. Once the engine starts allow to run for 10 seconds. Note. If the engine starts at all and then stops, even for 1 sec, move the choke lever (18) to the mid way...

  • Page 16: Stopping The Engine

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 16 5 stopping the engine emergency stopping procedure when it is completely necessary to stop the engine immediately, press the on/off switch (10) to the off position (position “o”) until t...

  • Page 17: Operating Instructions

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 17 5 operating instructions the operation of the rear rotating handle 1. The rotating handle (20) can turn left or right up to 90°. 2. The rotating handle (20) can only be adjusted when the...

  • Page 18: Operating Instructions

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 18 5 operating instructions • never operate the hedge trimmer without a properly functioning muffler and spark plug cover installed. • ensure that the blade cover is removed before starting...

  • Page 19: Operating Instructions

    19 s u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 5 operating instructions 1. Practice a little with the new orientation of the tool. The balance and feel is slightly different than in the horizontal position. 2. Fill the fuel tank full...

  • Page 20: Maintenance

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 20 5 maintenance warning. Ensure the engine is switched off before undertaking all maintenance work / tasks. Blade maintenance your hedge trimmer should be stopped and oiled occasionally du...

  • Page 21: Maintenance

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 21 5 maintenance air filter caution. Never operate this unit without the air filter as dust and dirt will be sucked into the engine and damage it. Accumulated dust in the air filter will re...

  • Page 22: Storage

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 22 storage and maintenance after use 1. Perform all the general maintenance recommended in the maintenance section of your instruction manual. 2. Clean the outside surfaces of the hedge tri...

  • Page 23: Removing A Unit From Storage

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 23 removing a unit from storage 1. Remove spark plug (6). 2. Pull the recoil starter (8) briskly to clear excess oil from the combustion chamber. 3. Clean and gap the spark plug (6) or inst...

  • Page 24: Troubleshooting

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 24 5 troubleshooting problem possible cause solution unit won’t start or starts but will not run. • incorrect starting procedures. • incorrect carburettor mixture adjustment setting. • foul...

  • Page 25

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 25 this is a blank page.

  • Page 26

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 26 this is a blank page.

  • Page 27

    S u a 1800 909 909 www.Powertoolsupport.Com email: help@powertoolsupport.Com 11/2015 after sales support 43671 27 this is a blank page.

  • Page 28

    After sales support model: htks26 product code: 43671 11/2015 year warranty 2 1800 909 909 www.Powertoolsupport.Com aus.