Gardenline Hedge Trimmer User Manual - Operating Instructions
S
U
A
1800 909 909
www.powertoolsupport.com email: help@powertoolsupport.com 11/2015
AFTER SALES SUPPORT
43671
18
5
Operating Instructions
• Never operate the hedge trimmer without a properly functioning muffler and spark
plug cover installed.
• Ensure that the blade cover is removed before starting the hedge trimmer.
• Never operate the hedge trimmer unless it is properly assembled and in good
working condition.
• Start the engine only when you are close to the working area.
• Always trim or cut at high engine speeds. Do not run the engine slowly at the start
or during trimming operations.
• Place yourself in a well-balanced position, stable on both feet.
• Avoid cutting thick branches (larger than 24mm), as this will damage the blades and
shorten the life of the drive system.
• Always keep your body to the carburettor side of your trimmer, never on the
muffler side.
• Maintain a steady, even posture while operating. Do not over-reach.
• If the blades jam when operating, switch the engine off and clear any obstruction.
WARNING.
Wear gloves whenever touching the blades.
• If the blades connect with a hard object during operation stop the engine and check
the blade for damage.
• Never work towards people or solid objects such as walls, trees or vehicles etc.
• Always release the throttle trigger and allow the engine to return to idle speed
when not cutting.
• DO NOT jam the controls in the on/fast condition. Operate the controls by hand only.
• Always check the product to be trimmed and do not cut close to fencing wire, or
services but not limited to electricity, gas pipes etc. ALWAYS check first.
• Always use the trimmer in a supply of fresh air. Do Not use in confined or enclosed
areas.
• If the hedge trimmer is making unusual sounds or vibrations, turn the unit off
immediately; do not under any conditions leave the hedge trimmer operating and
unattended. Disconnect the spark plug and inspect for damage or any loose parts.
Also reference the trouble shooting chart or take it to an authorised service agent.
Using the Hedge Trimmer with the Trimmer on its side.
Often, when either of the rotating handle (20) positions, i.e 90° to the left or the
right is selected, the hedge trimmer will be orientated with the blade (1) in a vertical
position. Please note the following tips.