Gardenline Hedge Trimmer User Manual - Operating Instructions
S
U
A
1800 909 909
www.powertoolsupport.com email: help@powertoolsupport.com 11/2015
AFTER SALES SUPPORT
43671
15
Operating Instructions
5
7. Once the engine starts allow to run for 10 seconds.
Note.
If the engine starts at all and then stops, even for 1 sec,
move the choke lever (18) to the mid way position between the
full choke and no choke position and pull the recoil starter (8)
to re start.
WARNING.
On start up the oscillating blades may be
operational due to the setting of the starting throttle. Be well
aware of this condition
8. Move the red choke lever (18) to the no choke position
(Fig 4b) and allow to run for a further 10 sec.
9. After the motor is operating and partly warmed after point 8 above, grip the
rear handle (15) of the hedge trimmer and at the same time press down the
safety lever (14). Squeeze slightly the throttle trigger (11) and then release the trigger.
This will disengage the starting trigger lock and allow the motor to idle correctly and
disengage the oscillating blades.
10. If the engine fails to start, repeat steps 1 through 8.
WARNING.
On start up the oscillating blades may be operational due to the
setting of the starting throttle. Be well aware of this condition.
Note.
If the engine fails to start after repeated attempts,
refer to Troubleshooting section.
Note.
Always pull the recoil starter (8) straight out. Pulling the recoil starter (8)
at an angle will cause it to rub against the eyelet. This friction will cause the cord
to fray and wear more quickly. Do not pull the end of the cord, this can damage
the recoil starter (8). Always hold the recoil starter (8) handle when the cord
retracts. Never allow the cord to snap back from the extended position. This could
cause the cord to snag or fray and also damage the recoil starter (8) assembly.
Fig. 4b