Garland MWE3S Installation And Operation Manual - Installation & Startup (
PART #4521777 (10/09/09)
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
INSTALLATION/OPERATION MANUAL
Page 17
INSTALLATION & STARTUP (
continued
)
Startup Procedure
This Garland 3-platen grill comes with a factory startup
at no additional charge. A startup is required to take
place
BEFORE
the unit is put into operation. It is the
end-user responsibility to schedule the startup with their
local Factory Authorized Service Agent, or notify Garland
Commercial Industries at 1-800-446-8367 should you need
assistance scheduling.
A factory startup is a comprehensive grill check in which
a factory certified technician will document all final
settings programmed in the controller once various other
performance checks are complete. The estimated time
to complete a startup is approximately 2.5 – 3.5 hours.
Please keep in mind this estimated time when scheduling
the startup. After hours or overtime is not covered under
warranty and will be billed at a charge which is the
difference between the Garland Reimbursement rate and
the Factory Authorized Service Centers overtime charges.
A factory startup is necessary to start the warranty period.
The Authorized Service Center is required to complete
the paperwork during the startup process, and send it to
Garland Commercial Industries for reimbursement. At
the time of receipt, Garland will start the warranty period
which will conclude at the end of 2 years. You may contact
your Kitchen Equipment Supplier or dial 1-866-735-1955
for more details regarding an optional 3rd year extended
warranty plan.
Exhaust hood Type & Platen Height
With the platens in the raised position, measure the
height from the front edge of the platen to the grill
surface. Determine which type of exhaust hood the
store has and check for exhaust hood type/platen
height compatibility according to the table below:
Exhaust hood
TYPE
CORRECT PLATEN HEIGHT
Universal
18
1
⁄
2
” (470mm)
92 Series
17” (432mm)
GSC
18
1
⁄
2
” (470mm)
If the platen height is incompatible with the exhaust
hood type, platen height must be adjusted by an
authorized service agent.
PLATEN
HEIGHT
GRILL
PLATE