Garmin EDGE 500 Quick Start Manual - Open

Edge 500 Owner’s Manual 

ANT+ Sensors

2.  Use a coin to twist the cover 

counter-clockwise so the arrow on 

the cover points to 

OPEN

. 

3.

Remove the cover and battery. 

4.  Wait 30 seconds. 

5.  Insert the new battery with the 

positive side facing up.

NOTE: Be careful not to damage 

or lose the O-ring gasket on the 

cover. 

6.  Use a coin to twist the cover 

clockwise so the arrow on the cover 

points to 

CLOSE

.

Installing the GSC 10

Both magnets must be aligned with 

their respective indication lines for the 

Edge to receive data. 

1.  Place the GSC 10 on the rear chain 

stay (on the side opposite the drive 

train). 

NOTE: Place the flat rubber pad 

or the triangle-shaped rubber pad 

between the GSC 10 and the chain 

stay for stability.