Garmin Flight Stream 110/210 Installation Manual - page 19
190-01700-00
Flight Stream 110/210 TSO Installation Manual
Rev. B
Page 2-2
2.3 Special Tools Required
Table 2-2. Pin Contact Numbers
Table 2-3. Recommended Crimp Tools
NOTE
Non-Garmin part numbers shown are not maintained by Garmin and are subject to
change without notice.
2.4 Cabling and Wiring
Wiring should be installed in accordance with AC 43.13-1B Chapter 11. When wire separation cannot be
achieved, the following issues should be addressed:
•
The cable harness should not be located near flight control cables, high electrical capacity lines, or
fuel lines.
•
The cable harness should be located in a protected area of the aircraft.
•
Do not route cable near high-energy sources.
See the interconnection diagrams in appendix B for the appropriate wiring. Once the cable assemblies have
been made, attach the cable connector. Route the wiring bundle as appropriate. Avoid sharp bends.
For the Flight Stream, use 22 AWG wire for all connections including power/ground.
CAUTION
Check wiring connections for errors before connecting the 15-pin D-sub to the Flight
Stream. Incorrect wiring could cause component damage.
2.5 Mounting Requirements
The Flight Stream may be mounted in a pressurized or unpressurized location. To achieve optimal
Bluetooth reception, mount the Flight Stream as close as possible to the cockpit.
Wire Gauge
15-pin connectors
20-24 AWG
Garmin P/N
336-00021-00
Military P/N
M39029/58-360
Wire Gauge
Hand Crimping Tool
20-24 AWG
Positioner
Insertion/Extraction
Tool
Military P/N
M22520/2-01
M22520/2-09
M81969/1-04
Positronic
9507
9502-4
M81969/1-04
AMP
601966-1
601966-6
91067-1
Daniels
AFM8
K42
DAK95-22MB/
DRK95-22MB
Astro
615717
615725
M81969/1-04